9.4 Current satellite list
The satellite positions stored in memory are shown in the satellite list. Any positions not yet stored in memory are marked with an “*”.
>To adjust the antenna dish to a position on the satellite list, use the arrow keys to select the field Current Satellite list.
>Confirm by pressing OK.
>Use the arrow keys up/down to select the desired position.
>Confirm by pressing OK.
The antenna dish will now be rotated to the selected position. The rotating procedure will be indicated by a blinking display “rotating” in the menu.
9.4.1 Selecting a satellite position
To rotate the antenna to the position determined in the satellite list, your digital receiver is equipped with the function turn to Sat.
>Press the yellow function key Actions to open the window displaying the available actions.
>Use the arrow keys up/down to select the line turn to Sat.
>Confirm by pressing OK.
>Pressing the green key turn to Sat will rotate the antenna to the selected satellite position.
9.5 Deleting a satellite position
To delete a satellite position from the satellite list, proceed as follows:
>Use the arrow keys to mark the field Current Satellite list.
>Press OK to open the current satellite list.
>Use the arrow keys up/down to select the satellite you wish to delete.
>Confirm by pressing OK.
>Use the arrow keys to mark the field Sat delete.
>To delete the satellite selected, press OK and confirm the message displayed by again pressing OK.
9.6 Reference position
When installing the external installation the motor must be set to the reference position (0°). You can therefore rotate the motor to this position (0°) at any time by means of the function “Go to reference position”.
>Press the red function key Ref.pos to rotate the antenna automatically to the reference position.
58