Dolby Laboratories Digital-Satellite-Receiver manual Storing a satellite position

>Now use the arrow key right (field East will be marked) resp. left (field West will be marked) to rotate the antenna to the desired position. Keep the appropriate key depressed until the desired position is reached.

9.3.2.3 Automatic detail adjustment (Autofocus)

Before storing the satellite position in memory you should perform an automatic focussing procedure. This will set the antenna to optimum reception in terms of measurable parameters.

>Press the yellow function key Actions to open the window showing the actions available.

>Now use the arrow keys up/down to mark the line

Auto Focus.

>Confirm by pressing OK.

>Press the green key Auto Focus to start the auto- focus procedure.

The message Auto Focus (Fig. 9-13)will be dis- played while the automatic adjustment is in progress.

9.3.3 Storing a satellite position

Once you have completed work on the function Autofocus, you must still store the satellite position in memory.

>Use the arrow keys to mark the field Store.

>Press OK.

The test transponder set will now check whether a sig- nal is being received at this position. It will also check whether the position corresponds with one of the pre- programmed positions. (Fig. 9-14)

If this is the case, the following message will be dis- played: Orbital position xx found. Store satellite ? (Fig. 9-15)

>To store the satellite position, use the arrow keys right/left to mark the field Yes and confirm by pressing OK.

If the test transponder procedure does not recognize a pre-programmed position, or if the signal received is too weak, appropriate messages will be displayed on screen. (Figs. 9-16 and 9-17)

>To store the satellite position in memory, use the arrow keys right/left to mark the field Yes and confirm by pressing OK.

(Fig. 9-13)

(Fig. 9-14)

(Fig. 9-15)

(Fig. 9-16)

(Fig. 9-17)

57