(Fig.
(Fig.
(Fig.
(Fig.
*Only for receivers equipped with this feature
8.6 Conditional Access*
Use this menu item to access the
CI slot*, and confirm by pressing OK to view information on the Smartcard or the CI module used.
9 Operation in conjunction with a rotating antenna (DiSEqC 1.2)
Your digital receiver is equipped for operation in conjunction with a rotating antenna installation. The DiSEqC control func- tion
>Call up the menu Antenna Settings as described in Point 6.4 (Fig.
>Now use the arrow keys up/down to select the DiSEqC position (e.g. A/B 3) to which you wish to allocate the motorized rotating antenna.
>Press OK to display a selection window for the
Satellite resp. for the Motor antenna. (Fig.
>Use the arrow keys up/down to mark the line Motor antenna and confirm by pressing OK.
>Read the note on setting Eastern and Western limits (Fig.
9.1 Eastern and Western limits
To avoid mechanical damage to the dish antenna or the LNC by obstacles in its path, the maximum rotating range in both easterly and westerly direction must be set. If there are any obstacles (e.g. a wall, chimney, etc.) within the rotating radius of the antenna, this must be considered when setting the rotating limits. If there are no obstacles to consider, you should set the limits so that they extend a little beyond the positions of the most easterly and westerly satellite positions you wish to receive.
9.1.1 Deleting existing limits
At the outset, you should delete any existing limit settings.
>Use the arrow keys right/left to mark the column
Configuration.
>In the line Motor antenna use the arrow keys up/down to mark the field Proceed.
>Confirm by pressing OK.
The menu relating to settings for the motor antenna will be displayed. (Fig.
52