Remote Control Setup
Teaching Another Remote Control
1Press the MENU button, select System Setup (6), and then select Diagnostics (3). The receiver displays the blank System Diagnostic Tests screen.
2Select the Teach Remote option. The receiver displays a pop up screen warning that you must press any button on the front panel to quit the teaching mode.
3If you want to continue, select the Yes option. The receiver now displays the System Diagnostic Tests screen containing further instructions.
4Aim both remotes at the receiver. Press one button at a time on your DISH Network remote, while pressing the button to be taught on the universal learning remote at the same time. Repeat this process for each button you want to be taught to the learning remote.
Note: Any button on the DISH Network remote that is not used with your DISH Network receiver will not teach the universal learning remote.
5You can quit the teaching mode at any time by either of the two following methods:
•Press any front panel button on your receiver.
•Leave the receiver alone for at least three minutes.
The receiver again displays the blank System Diagnostic Tests screen. You can cancel out of this screen back to your original viewing screen.
57