Sony MAV-555SS operation manual Editing Panel Monitor

(2) 2 input/2 output configuration when a linear editing device is connected

Editing Panel	Monitor	Monitor
MAVE-F555

- +

Chapter

Video Camera

SDI/Composite

					monitor
						Composite
	R2/		VIDEO
	R1	P1	INPUT	REMOTE
PORT SELECT
	P3	P2

HELP

RS-422

MENU

Composite

RS-422

	SETUP	Composite
CONTROL PANEL	SELECT PANEL SELECT CHARACTER

monitor

Editing Control Unit

BVE-600

3 Preparations

MAV-555SS

REF.

Analog Audio Expansion Unit

BKMA-570

Sync Generator

Analog audio	Analog audio	Analog audio	audio
			Analog

Analog Audio Mixer

MXP-29

RS-422 Composite

monitor

VTR

Monitor

•In the BVE mode, the Record port (R1) and the Play port (P1) are combined, so the unit can serve as the VTR of a re-recorder (a combination recording and playback port is called an RP port). This means that recording at the R2 port while editing is possible.

•To begin editing, execute the Linear Edit New Material command from the optional BKMA-505 Control Panel to create a BLACK/MUTING file. This file is assigned to the RP port. The length of the initial file must be specified by LINEAR EDIT NEW FILE (menu 321) beforehand.

•When performing four-channel editing with a two-channel audio editor, select ANALOG AUDIO EDIT PRESET REPLACE (menu 307) on the expansion menu.

•For two-channel audio editing, use the BKMA-570 Analog Audio Expansion Unit. If not enough analog audio connectors are available for wiring of the system, channel 1 and 2 audio can be output from the channel 3 and 4 terminals by setting 821 AUDIO OUTPUT CHANNEL on setup menu 821.

•In BVE mode, only 2 input/2 output and 1 input/3 output configurations can be used.

3-8 (E) 3-1 MAV-555SS Modes