Sony MAV-555SS Blanking Width P1, Blanking Width P2, Blanking Width P3, Selection of VIDEO/SYNC

Expansion menu items (Continued)

Item number	Display indication	Settings	Description
768	H BLANKING WIDTH P1	These items select the horizontal blanking width for the video output signal. If
769	H BLANKING WIDTH P2	analog blanking was selected, the horizontal blanking width conforms with the
770	H BLANKING WIDTH P3	RS170A. The wider the blanking width, the narrower the picture is.
BI		narrow	: Digital blanking (narrow)
		wide	: Analog blanking (wide)
778	SELECTION OF VIDEO/SYNC	Selects the video output phase that is set for PB/EE on the 013 Setup menu.
BI	DELAY MONITOR	VIDEO DELAY		: Ignores video signal delays and adds the same sync as the output ref
				to the video output. In this case, the picture moves downward when
				in EE mode.
		SYNC DELAY		: Adds a sync signal that is offset to match the video signal delay.
779	VAR CONROL P1	These items set up the video process.
780	VAR CONROL P2
781	VAR CONROL P3
BI
	SUB MENU
	Y ADD	This item specifies whether to forcibly turn Y ADD off in a playback mode other than
		normal playback mode (JOG, VAR, SHUTTLE, STILL, etc.).
		auto	: Perform Y ADD automatically in any playback mode other than normal
			playback mode.
		off	: Forcibly turn Y ADD off in any playback mode other than normal
			playback mode.
	ESR	When recording or playing back a composite signal, this item specifies whether to
		automatically turn the edge subcarrier reducer on/off in accordance with the playback
		mode, or to force the edge subcarrier reducer on (in order to play back a non-standard
		signal).
		auto	: Turn the edge subcarrier reducer on/off in accordance with the playback
			mode.
		on	: Force the edge subcarrier reducer on.
782	INTERNAL SIGNAL	These items select the test signal that is output from the internal signal generator.
	GENERATOR R1	When off:
783	INTERNAL SINGAL	No test signal is generated, and the unit operates normally.
	GENERATOR R2	When not off:
784	INTERNAL SINGAL	If an INPUT SELECT switch is held down for at least three seconds while lit, all INPUT
	GENERATOR R3	SELECT switches light and the internal signal generator operates. The selected test
		signal is input to the REC port. It is also possible to record this signal.
		off	: No test signal is generated.
		CB100	: 100% color bar signal
		CB75	: 75% color bar signal
		CB75R	: 75% color bar (reverse) signal
		BOW	: Bowtie signal
		PLSBR	: Pulse and bar signal
		MLTBS	: Multi-burst signal
		HSWP	: HSWP signal (available only in 525 mode)
		5STEP	: 5-step signal
		RAMP	: Ramp signal
		SH	: Shallow ramp signal
		RED	: Full red signal
		GRAY	: 50% flat signal
		WHITE	: 100% flat signal
		BB	: Black burst signal
		SDI	: SDI check field signal
		NTC7	: NTC7 test signal (available only in 525 mode)
		LN330	: Line 330 test signal (available only in 525 mode)
785	INPUT VIDEO BLANK R1	These items turn blanking during the input video signal vertical blanking interval
786	INPUT VIDEO BLANK R2	on and off.
787	INPUT VIDEO BLANK R3
BI
	SUB MENU

Chapter 3 Preparations

3-4 Setup 3-37 (E)