PLUS Vision M-5 user manual Handling CF Memory Cards, Scanning area, Inserting CF memory cards

Handling CF Memory Cards

•We recommend backing up data stored in the built-in memory or on CF memory cards onto other recording media periodically to secure the data in case of damage or loss.

•Note that PLUS will accept no responsibility whatsoever for loss or damage of stored data.

•Please use a memory card having specifications that conform with the CompactFlash standard (which supports an

operating voltage of 3.3 V / 5 V).

* CompactFlash memory cards are referred to as “CF memory cards” in this manual.

Inserting CF memory cards

When using in the horizontal position

With the surface of the CF memory card facing the left, insert the card vertically, pressing it slowly to the end.

When using in the vertical position

With the surface of the CF memory card facing the up, insert the card horizontally, pressing it slowly to the end.

Note:

•Insert the CF memory card slowly.

•The slot is designed so the card cannot be inserted in the wrong direction. Trying to force it will result in damage.

	MEMORY
FEED/STOP
	POWER
	CLEAR
	SITIO	N
PO

M

E

M

O

R

Y

F E E D / S T O P

P

O

W

E

R

C

L

E

A

R

P

O

S

IT

IO

N

Removing the CF memory card

Check that the MEMORY indicator has stopped blinking and turned off, then pull the CF memory card out.

Note:

•Do not pull off the CF memory card or disconnect the AC power adapter’s cable while data is being stored in the memory (when the MEMORY indicator is blinking). Doing so will damage the data.

The CF memory card can be replaced while the MEMORY in- dicator is blinking intermittently, indicating there is not enough free memory left.

		MO	RY
	ME
	EDTO		P
FE /S
		W	ER
	PO
		EA	R
	CL
		IO
	SIT
PO

M

E

M

O

RY

F

EE

D

/ST

O

P

PO

W

ER

C

L

E

AR

POSITION

Scanning area

Effective scanning area

Scanning is not possible on the edges of sheet. Write or draw within the effective scanning area.

Notice: The effective vertical scanning area is within the ruled lines.

20mm	Area not scannable	20mm
23.5mm	978mm
	578mm
23.5mm	Effective scanning area

Notes on scanning the sheet surface

•When the POWER button is press to turn on the power or the MEMORY button is pressed while in the standby mode, the memory or feed operation starts after the warm-up. It is for stable sanning condition.

Under normal conditions, it takes about 20 seconds, but under certain environments, for example when the external temperature is low, some more time may be required. On this copyboard, this warm-up time is controlled by a timer and it can be changed with the setup utility.

To achieve a more stable picture quality, we recommend you to wait one minute after the fluorescent lamp turns on before storing images in the memory. The time required for operation to become stable depends on the environment.

•Note that images may not be read as well if you use markers of colors other than black and red or markers of other brands. Use the markers specified by PLUS.

•Avoid use in places exposed to abrupt changes in temperature such as near the vents of an air conditioner.

Doing so could result in the deterioration of read quality.

21