Philips DVP1120/93, DVP2008 manual Troubleshooting, Problem Solution

English

Troubleshooting

WARNING

Under no circumstances should you try to repair this unit yourself, as this invalidate the warranty. Do not open this unit as there is a risk of electric shock.

If a fault occurs, first check the points listed below before taking this unit for repair. If you are unable to remedy a problem by following these hints, consult your dealer or Philips for help.

Problem		Solution
No power.	–	Press 2 on the unit to turn on the power.
	–	Ensure that the AC outlet have power.
	–	Disconnect the power cord from the power outlet
		for a few minutes. Reconnect the power cord and try
		to operate again as usual.
No picture.	–	Refer to your TV manual for correct Video In channel
		selection. Change the TV channel until you see the
		DVD screen.
	–	If this happens when you turn on the progressive scan
		feature, wait for 15 seconds for the auto recovery or
		switch back to the default mode as below:
		1) Press ç on this unit.
		2) Press and hold numeric keypad ‘1’ on the remote
		control.
	–	If this happens after you set the colour system, wait
		for 15 seconds for the auto recovery or switch back
		to the default TV colour system:
		1) Press ç on this unit.
		2) Press and hold numeric keypad ‘3’ on the remote
		control.
Completely distorted picture	–	Check the video connection.
or black/white picture.	–	Ensure that the disc is compatible with this unit.
	–	Sometimes a small amount of picture distortion may
		appear. This is not a malfunction.
	–	The disc is dirty. Clean the disc.

36

1_dvp1120-2008_93_eng1_final813.36 36 2008-03-24 2:43:18 PM