Combi 8040 instruction manual Fig. a

Page 12

8040 (EN) 122904.qxd 12/29/04 9:17 PM Page 12

11

Positioning of shoulder harness and infant insert to fit infant’s size:

Check positioning of shoulder harness through seat back when first using the car seat and periodically after that to verify correct fit and positioning of the harness for infant’s size.

Shoulder harness straps MUST be through:

-Shoulder harness slots at or just below infant’s shoulders.

-Shoulder harness slots in infant insert.

See “Operation and Adjustment” section to change position of harness.

NOTE: Infant insert MUST always be used with	Infant Insert			Egg Shock
small infants (fig. a & b).				Egg Shock
				Foam
		Pocket

Egg shock foam MUST be used at all times.
Egg shock foam MUST be used at all times.
- When using infant insert, Egg Shock Foam MUST
be inside pocket on back of insert (see “Egg Shock
Foam” section).				Seat Pad
- When infant insert is NOT used, Egg Shock Foam				Seat Pad
- When infant insert is NOT used, Egg Shock Foam			(fig. a)	Pocket
MUST be inside pocket on back of seat pad.			(fig. a)	(fig. b)

Image 12

Contents Combi Connection Infant Car Seat 8040 EN 122904.qxd 12/29/04 917 PM 8040 EN 122904.qxd 12/29/04 917 PM Table of Contents Located on back of seat pad Connection Infant Car Seat Parts Carry Infant CAR SeatCAR Seat Base Proper Use Check List Height and Weight Limits Use RecommendationsSecuring Infant In Car Seat 8040 EN 122904.qxd 12/29/04 917 PM Fig. a Click fig. b See Harness Use and Adjustment section Rolled TowelSelecting a Vehicle Seating Location Options For Securing a Car Seat Latch System Latch System On This Car SeatLatch System On Vehicles Fig. c Installation of Infant Car Seat in Vehicle Removal Of Infant Car Seat From Base Attaching Infant Car Seat To BaseZone Recline Indicator Line StripedSecuring Base With Latch System Anchor Connectors LowerButton Anchor BeltGreen Striped ZoneRepeat for connector on opposite side Fig. fRemoval Of Base Installed With Latch Storage Of Lower Anchorage Belt And Lower Anchor Connectors Anchor ConnectorSecuring Base With Vehicle Seat Belt Fig. b Recline Indicator Down over outside of blue belt guide 4 fig. d Fig. e Securing Infant Car Seat Without Base Fig. b Green Striped Zone Fig. d Shoulder Belt GuideRemoval Of Infant Car Seat From Vehicle Stroller or Travel System Use Operation and Adjustment Harness Use and AdjustmentUnder Changing Use Position and Harness Length Shoulder Harness LoopsUnder Adjuster Cover Shoulder HarnessShoulder Harness Loop Tab Changing Shoulder Harness Slot Position Fig. d Adjustment Button Base Adjustment Adjuster HandleEgg Shock Foam Infant Insert Infant Insert Egg Shock Pad FoamCanopy Vehicle Seat Belt Systems Bight Belt Forward Buckle FlipLap Belts With Retractor Lap or Shoulder Belt Mounted on Front Door fig. f Combination Lap/Shoulder Belt with Free Sliding Latch Plate Locking Clip stored in pouch on back of car seat Car seat is secure Additional Information Certification Warm WeatherCare and Cleaning Cleaning SeatRe-use After a Crash Registration Information Limited Warranty 8040 EN 122904.qxd 12/29/04 917 PM Designed by Parents, for Parents