Combi 8040 instruction manual Securing Base With Latch System

Page 22

8040 (EN) 122904.qxd 12/29/04 9:17 PM Page 22

21

Securing Base With LATCH System:

WARNING DEATH or SERIOUS INJURY can occur

•Only use the car seat LATCH System in vehicle seating locations recommended by the vehicle manufacturer for use with LATCH and that have an anchor spacing of 280 mm (11 inches).

•LATCH connectors must be secured to the vehicle LATCH anchorages only. Connection to other vehicle components could result in the anchor tearing free in a crash.

•Never attach more than one anchor connector to a vehicle lower anchorage unless recommended by the vehicle owner’s manual for that vehicle.

1 Refer to vehicle owner’s manual to identify the seating locations with LATCH System. Select the seating location to be used and locate the vehicle lower anchorages at the seat bight.

A LATCH Anchorage System with 280 mm (11 inch) spacing may not be available in your vehicle in the rear center seating position. If use of the rear center position is preferred, use the vehicle seat belt to secure the car seat. See “Securing Base With Vehicle Seat Belt” section.

Image 22

Contents Combi Connection Infant Car Seat 8040 EN 122904.qxd 12/29/04 917 PM 8040 EN 122904.qxd 12/29/04 917 PM Table of Contents Located on back of seat pad Connection Infant Car Seat Parts Carry Infant CAR SeatCAR Seat Base Proper Use Check List Height and Weight Limits Use RecommendationsSecuring Infant In Car Seat 8040 EN 122904.qxd 12/29/04 917 PM Fig. a Click fig. b See Harness Use and Adjustment section Rolled TowelSelecting a Vehicle Seating Location Options For Securing a Car Seat Latch System On This Car Seat Latch SystemLatch System On Vehicles Fig. c Installation of Infant Car Seat in Vehicle Removal Of Infant Car Seat From Base Attaching Infant Car Seat To BaseZone Recline Indicator Line StripedSecuring Base With Latch System Anchor Connectors LowerButton Anchor BeltGreen Striped ZoneRepeat for connector on opposite side Fig. fRemoval Of Base Installed With Latch Storage Of Lower Anchorage Belt And Lower Anchor Connectors Anchor ConnectorSecuring Base With Vehicle Seat Belt Fig. b Recline Indicator Down over outside of blue belt guide 4 fig. d Fig. e Securing Infant Car Seat Without Base Fig. b Green Striped Zone Fig. d Shoulder Belt GuideRemoval Of Infant Car Seat From Vehicle Stroller or Travel System Use Harness Use and Adjustment Operation and AdjustmentUnder Changing Use Position and Harness Length Shoulder Harness LoopsShoulder Harness Under Adjuster CoverShoulder Harness Loop Tab Changing Shoulder Harness Slot Position Fig. d Adjustment Button Base Adjustment Adjuster HandleEgg Shock Foam Infant Insert Infant Insert Egg Shock Pad FoamCanopy Vehicle Seat Belt Systems Bight Belt Forward Buckle FlipLap Belts With Retractor Lap or Shoulder Belt Mounted on Front Door fig. f Combination Lap/Shoulder Belt with Free Sliding Latch Plate Locking Clip stored in pouch on back of car seat Car seat is secure Additional Information Certification Warm WeatherCare and Cleaning Cleaning SeatRe-use After a Crash Registration Information Limited Warranty 8040 EN 122904.qxd 12/29/04 917 PM Designed by Parents, for Parents