Combi 8040 instruction manual Lap Belts With Retractor

Page 49

8040 (EN) 122904.qxd 12/29/04 9:17 PM Page 49

Lap Belts - With Retractor

Lap belts with retractors (fig. d) may or may not hold a car seat securely.
Follow these steps to determine if you have a retractor system that will hold car seat
securely:
a. Pull belt all the way out.
b. Allow belt to retract about 6 inches (15 cm).
c. Pull out on belt again.
If belt is locked and you cannot pull the belt out any further, you have an Automatic	(fig. d)
Locking Retractor which may be used with a car seat. Remember, when installing a
car seat, pull belt all the way out, buckle belt, and then tighten.
If the belt pulls out (step c), the retractor is an Emergency Locking Retractor which must
not be used with a car seat.

48

Image 49

Contents Combi Connection Infant Car Seat 8040 EN 122904.qxd 12/29/04 917 PM 8040 EN 122904.qxd 12/29/04 917 PM Table of Contents Located on back of seat pad Carry Infant CAR Seat Connection Infant Car Seat PartsCAR Seat Base Proper Use Check List Use Recommendations Height and Weight LimitsSecuring Infant In Car Seat 8040 EN 122904.qxd 12/29/04 917 PM Fig. a Click fig. b Rolled Towel See Harness Use and Adjustment sectionSelecting a Vehicle Seating Location Options For Securing a Car Seat Latch System On This Car Seat Latch SystemLatch System On Vehicles Fig. c Installation of Infant Car Seat in Vehicle Attaching Infant Car Seat To Base Removal Of Infant Car Seat From BaseStriped Zone Recline Indicator LineSecuring Base With Latch System LowerButton Anchor Belt Anchor ConnectorsStriped Zone GreenFig. f Repeat for connector on opposite sideRemoval Of Base Installed With Latch Anchor Connector Storage Of Lower Anchorage Belt And Lower Anchor ConnectorsSecuring Base With Vehicle Seat Belt Fig. b Recline Indicator Down over outside of blue belt guide 4 fig. d Fig. e Securing Infant Car Seat Without Base Fig. b Green Striped Zone Fig. d Belt Guide ShoulderRemoval Of Infant Car Seat From Vehicle Stroller or Travel System Use Harness Use and Adjustment Operation and AdjustmentUnder Shoulder Harness Loops Changing Use Position and Harness LengthShoulder Harness Under Adjuster CoverShoulder Harness Loop Tab Changing Shoulder Harness Slot Position Fig. d Adjustment Button Adjuster Handle Base AdjustmentEgg Shock Foam Infant Insert Egg Shock Pad Foam Infant InsertCanopy Vehicle Seat Belt Systems Flip Bight Belt Forward BuckleLap Belts With Retractor Lap or Shoulder Belt Mounted on Front Door fig. f Combination Lap/Shoulder Belt with Free Sliding Latch Plate Locking Clip stored in pouch on back of car seat Car seat is secure Certification Warm Weather Additional InformationCleaning Seat Care and CleaningRe-use After a Crash Registration Information Limited Warranty 8040 EN 122904.qxd 12/29/04 917 PM Designed by Parents, for Parents