Combi 8040 instruction manual Green, Striped Zone

Page 24

8040 (EN) 122904.qxd 12/29/04 9:17 PM Page 24

23

7Place base rear-facing in the vehicle seat location selected with blue lap belt guides toward vehicle seat back and centered between the vehicle lower anchors (fig. d).

Attach car seat to base.

8Adjust recline using recline indicator on the side of the car seat. Line of recline indicator MUST be in green striped zone (fig. e). If line is not in green striped zone, adjust base using recline foot (see “Base Adjustment” section), and recheck recline of car seat. Repeat until recline indicator is in green striped zone.

If base can not be adjusted to locate the line in the green striped zone:

1.If necessary, place tightly rolled towel, pool noodle, or firm object under recline foot to level car seat.

2.Try a different seating position.

3.Do not use this infant car seat.

NOTE: Vehicle must be parked on horizontal surface

during this installation.
9 Remove car seat from base.	Green
9 Remove car seat from base.	Striped Zone

(fig. d)

(fig. e)

Recline

Indicator

Image 24

Contents Combi Connection Infant Car Seat 8040 EN 122904.qxd 12/29/04 917 PM 8040 EN 122904.qxd 12/29/04 917 PM Table of Contents Located on back of seat pad Connection Infant Car Seat Parts Carry Infant CAR SeatCAR Seat Base Proper Use Check List Height and Weight Limits Use RecommendationsSecuring Infant In Car Seat 8040 EN 122904.qxd 12/29/04 917 PM Fig. a Click fig. b See Harness Use and Adjustment section Rolled TowelSelecting a Vehicle Seating Location Options For Securing a Car Seat Latch System Latch System On This Car SeatLatch System On Vehicles Fig. c Installation of Infant Car Seat in Vehicle Removal Of Infant Car Seat From Base Attaching Infant Car Seat To BaseZone Recline Indicator Line StripedSecuring Base With Latch System Anchor Connectors LowerButton Anchor BeltGreen Striped ZoneRepeat for connector on opposite side Fig. fRemoval Of Base Installed With Latch Storage Of Lower Anchorage Belt And Lower Anchor Connectors Anchor ConnectorSecuring Base With Vehicle Seat Belt Fig. b Recline Indicator Down over outside of blue belt guide 4 fig. d Fig. e Securing Infant Car Seat Without Base Fig. b Green Striped Zone Fig. d Shoulder Belt GuideRemoval Of Infant Car Seat From Vehicle Stroller or Travel System Use Operation and Adjustment Harness Use and AdjustmentUnder Changing Use Position and Harness Length Shoulder Harness LoopsUnder Adjuster Cover Shoulder HarnessShoulder Harness Loop Tab Changing Shoulder Harness Slot Position Fig. d Adjustment Button Base Adjustment Adjuster HandleEgg Shock Foam Infant Insert Infant Insert Egg Shock Pad FoamCanopy Vehicle Seat Belt Systems Bight Belt Forward Buckle FlipLap Belts With Retractor Lap or Shoulder Belt Mounted on Front Door fig. f Combination Lap/Shoulder Belt with Free Sliding Latch Plate Locking Clip stored in pouch on back of car seat Car seat is secure Additional Information Certification Warm WeatherCare and Cleaning Cleaning SeatRe-use After a Crash Registration Information Limited Warranty 8040 EN 122904.qxd 12/29/04 917 PM Designed by Parents, for Parents