Combi 8040 instruction manual Fig. b Green Striped Zone

Page 33

8040 (EN) 122904.qxd 12/29/04 9:17 PM Page 33

5

6

Press down firmly on car seat to compress vehicle seat cushion while tightening vehicle lap belt (fig. b).

Adjust recline using the recline indicator on the side of

car seat (fig. c). Line on recline indicator must be in green striped zone.

If line is not in green striped zone, place a tightly rolled up towel, blanket or firm foam (pool noodle) under end of car seat contacting vehicle seat back.

If car seat can not be adjusted to locate the line in the green striped zone:

1.Try a different seating position.

2.Do not use this infant car seat.

NOTE: Vehicle must be parked on horizontal surface during this installation.

(fig. b)

Green Striped
Zone	(fig. c)
	(fig. c)
Recline
Indicator

32

Image 33

Contents Combi Connection Infant Car Seat 8040 EN 122904.qxd 12/29/04 917 PM 8040 EN 122904.qxd 12/29/04 917 PM Table of Contents Located on back of seat pad Carry Infant CAR Seat Connection Infant Car Seat PartsCAR Seat Base Proper Use Check List Use Recommendations Height and Weight LimitsSecuring Infant In Car Seat 8040 EN 122904.qxd 12/29/04 917 PM Fig. a Click fig. b Rolled Towel See Harness Use and Adjustment sectionSelecting a Vehicle Seating Location Options For Securing a Car Seat Latch System Latch System On This Car SeatLatch System On Vehicles Fig. c Installation of Infant Car Seat in Vehicle Attaching Infant Car Seat To Base Removal Of Infant Car Seat From BaseStriped Zone Recline Indicator LineSecuring Base With Latch System LowerButton Anchor Belt Anchor ConnectorsStriped Zone GreenFig. f Repeat for connector on opposite sideRemoval Of Base Installed With Latch Anchor Connector Storage Of Lower Anchorage Belt And Lower Anchor ConnectorsSecuring Base With Vehicle Seat Belt Fig. b Recline Indicator Down over outside of blue belt guide 4 fig. d Fig. e Securing Infant Car Seat Without Base Fig. b Green Striped Zone Fig. d Belt Guide ShoulderRemoval Of Infant Car Seat From Vehicle Stroller or Travel System Use Operation and Adjustment Harness Use and AdjustmentUnder Shoulder Harness Loops Changing Use Position and Harness LengthUnder Adjuster Cover Shoulder HarnessShoulder Harness Loop Tab Changing Shoulder Harness Slot Position Fig. d Adjustment Button Adjuster Handle Base AdjustmentEgg Shock Foam Infant Insert Egg Shock Pad Foam Infant InsertCanopy Vehicle Seat Belt Systems Flip Bight Belt Forward BuckleLap Belts With Retractor Lap or Shoulder Belt Mounted on Front Door fig. f Combination Lap/Shoulder Belt with Free Sliding Latch Plate Locking Clip stored in pouch on back of car seat Car seat is secure Certification Warm Weather Additional InformationCleaning Seat Care and CleaningRe-use After a Crash Registration Information Limited Warranty 8040 EN 122904.qxd 12/29/04 917 PM Designed by Parents, for Parents