Combi 8040 instruction manual Combination Lap/Shoulder Belt with Free Sliding Latch Plate

Page 51

8040 (EN) 122904.qxd 12/29/04 9:17 PM Page 51

Combination Lap/Shoulder Belt with Free Sliding Latch Plate

Pull out on latch plate. If belt slides freely through latch plate (fig. g), the locking clip MUST be used (see “Locking Clip” section).

- For rear-facing, use the locking clip to secure the lap belt (see “Locking Clip” section).

- For forward-facing, use the locking clip to secure the lap/shoulder belt.

Some combination lap/shoulder belts with free sliding latch plates may be
converted into an “automatic locking mode”. Always use the belt lock-off with
these belt systems.	(fig. g)
Combination Lap/Shoulder Belt with Locking Latch Plate
Vehicle seat belts with locking latch plates (fig. h) normally hold a car seat
tightly. However in some cases, the locking latch plate on some seat belts
may slip and loosen after being buckled on car seat if positioned at a certain	Flip
angle. If this happens, flip the latch plate over and re-buckle. Test installation	Flip
again to see if this works. If not, move car seat to another seating location.

50

(fig. h)

Image 51

Contents Combi Connection Infant Car Seat 8040 EN 122904.qxd 12/29/04 917 PM 8040 EN 122904.qxd 12/29/04 917 PM Table of Contents Located on back of seat pad Carry Infant CAR Seat Connection Infant Car Seat PartsCAR Seat Base Proper Use Check List Use Recommendations Height and Weight LimitsSecuring Infant In Car Seat 8040 EN 122904.qxd 12/29/04 917 PM Fig. a Click fig. b Rolled Towel See Harness Use and Adjustment sectionSelecting a Vehicle Seating Location Options For Securing a Car Seat Latch System Latch System On This Car SeatLatch System On Vehicles Fig. c Installation of Infant Car Seat in Vehicle Attaching Infant Car Seat To Base Removal Of Infant Car Seat From BaseStriped Zone Recline Indicator LineSecuring Base With Latch System LowerButton Anchor Belt Anchor ConnectorsStriped Zone GreenFig. f Repeat for connector on opposite sideRemoval Of Base Installed With Latch Anchor Connector Storage Of Lower Anchorage Belt And Lower Anchor ConnectorsSecuring Base With Vehicle Seat Belt Fig. b Recline Indicator Down over outside of blue belt guide 4 fig. d Fig. e Securing Infant Car Seat Without Base Fig. b Green Striped Zone Fig. d Belt Guide ShoulderRemoval Of Infant Car Seat From Vehicle Stroller or Travel System Use Operation and Adjustment Harness Use and AdjustmentUnder Shoulder Harness Loops Changing Use Position and Harness LengthUnder Adjuster Cover Shoulder HarnessShoulder Harness Loop Tab Changing Shoulder Harness Slot Position Fig. d Adjustment Button Adjuster Handle Base AdjustmentEgg Shock Foam Infant Insert Egg Shock Pad Foam Infant InsertCanopy Vehicle Seat Belt Systems Flip Bight Belt Forward BuckleLap Belts With Retractor Lap or Shoulder Belt Mounted on Front Door fig. f Combination Lap/Shoulder Belt with Free Sliding Latch Plate Locking Clip stored in pouch on back of car seat Car seat is secure Certification Warm Weather Additional InformationCleaning Seat Care and CleaningRe-use After a Crash Registration Information Limited Warranty 8040 EN 122904.qxd 12/29/04 917 PM Designed by Parents, for Parents