Combi 8040 instruction manual Anchor Connectors, LowerButton Anchor Belt

Page 23

8040 (EN) 122904.qxd 12/29/04 9:17 PM Page 23

2

3

4

5

If vehicle seat back is adjustable, adjust vehicle seat back into

most upright position.LATCH Lower

Anchor Connectors

Remove car seat from base.

Lift the LATCH lower anchor connectors out of the base (fig. a).

Lengthen lower anchor belt. While pressing adjuster release button, pull belt to extend the length of lower anchor belt (fig. b).

6

Place lower anchor belt over side of base and into belt slot in vehicle lap belt guide (fig. c).

Repeat for opposite side.

(fig. a)

Pull

Adjuster

Vehicle Lap

Belt Slot

7

Check that the belts are not twisted.Release

LowerButton

Anchor

Belt

22

(fig. b)

(fig. c)

Image 23

Contents Combi Connection Infant Car Seat 8040 EN 122904.qxd 12/29/04 917 PM 8040 EN 122904.qxd 12/29/04 917 PM Table of Contents Located on back of seat pad Carry Infant CAR Seat Connection Infant Car Seat PartsCAR Seat Base Proper Use Check List Use Recommendations Height and Weight LimitsSecuring Infant In Car Seat 8040 EN 122904.qxd 12/29/04 917 PM Fig. a Click fig. b Rolled Towel See Harness Use and Adjustment sectionSelecting a Vehicle Seating Location Options For Securing a Car Seat Latch System On Vehicles Latch SystemLatch System On This Car Seat Fig. c Installation of Infant Car Seat in Vehicle Attaching Infant Car Seat To Base Removal Of Infant Car Seat From BaseStriped Zone Recline Indicator LineSecuring Base With Latch System LowerButton Anchor Belt Anchor ConnectorsStriped Zone GreenFig. f Repeat for connector on opposite sideRemoval Of Base Installed With Latch Anchor Connector Storage Of Lower Anchorage Belt And Lower Anchor ConnectorsSecuring Base With Vehicle Seat Belt Fig. b Recline Indicator Down over outside of blue belt guide 4 fig. d Fig. e Securing Infant Car Seat Without Base Fig. b Green Striped Zone Fig. d Belt Guide ShoulderRemoval Of Infant Car Seat From Vehicle Stroller or Travel System Use Under Operation and AdjustmentHarness Use and Adjustment Shoulder Harness Loops Changing Use Position and Harness LengthShoulder Harness Loop Tab Under Adjuster CoverShoulder Harness Changing Shoulder Harness Slot Position Fig. d Adjustment Button Adjuster Handle Base AdjustmentEgg Shock Foam Infant Insert Egg Shock Pad Foam Infant InsertCanopy Vehicle Seat Belt Systems Flip Bight Belt Forward BuckleLap Belts With Retractor Lap or Shoulder Belt Mounted on Front Door fig. f Combination Lap/Shoulder Belt with Free Sliding Latch Plate Locking Clip stored in pouch on back of car seat Car seat is secure Certification Warm Weather Additional InformationCleaning Seat Care and CleaningRe-use After a Crash Registration Information Limited Warranty 8040 EN 122904.qxd 12/29/04 917 PM Designed by Parents, for Parents