Combi 8040 instruction manual Removal Of Base Installed With Latch, Fig. a

Page 26

8040 (EN) 122904.qxd 12/29/04 9:17 PM Page 26

25

12Attach car seat to base.

13Recheck recline of car seat. Adjust if necessary (see step 8).

Removal Of Base Installed With LATCH:

1Loosen lower anchor belt:

2

3

-While pressing down in center of base to reduce tension on lower anchorage belt, push adjuster release button and loosen belt.

Remove lower anchor connector:

-Press and hold the red release button.

-Pull the connector off the vehicle anchorage bar (fig. a).

Repeat to remove connector on opposite side.

(fig. a)

Image 26

Contents Combi Connection Infant Car Seat 8040 EN 122904.qxd 12/29/04 917 PM 8040 EN 122904.qxd 12/29/04 917 PM Table of Contents Located on back of seat pad Connection Infant Car Seat Parts Carry Infant CAR SeatCAR Seat Base Proper Use Check List Height and Weight Limits Use RecommendationsSecuring Infant In Car Seat 8040 EN 122904.qxd 12/29/04 917 PM Fig. a Click fig. b See Harness Use and Adjustment section Rolled TowelSelecting a Vehicle Seating Location Options For Securing a Car Seat Latch System On Vehicles Latch SystemLatch System On This Car Seat Fig. c Installation of Infant Car Seat in Vehicle Removal Of Infant Car Seat From Base Attaching Infant Car Seat To BaseZone Recline Indicator Line StripedSecuring Base With Latch System Anchor Connectors LowerButton Anchor BeltGreen Striped ZoneRepeat for connector on opposite side Fig. fRemoval Of Base Installed With Latch Storage Of Lower Anchorage Belt And Lower Anchor Connectors Anchor ConnectorSecuring Base With Vehicle Seat Belt Fig. b Recline Indicator Down over outside of blue belt guide 4 fig. d Fig. e Securing Infant Car Seat Without Base Fig. b Green Striped Zone Fig. d Shoulder Belt GuideRemoval Of Infant Car Seat From Vehicle Stroller or Travel System Use Under Operation and AdjustmentHarness Use and Adjustment Changing Use Position and Harness Length Shoulder Harness LoopsShoulder Harness Loop Tab Under Adjuster CoverShoulder Harness Changing Shoulder Harness Slot Position Fig. d Adjustment Button Base Adjustment Adjuster HandleEgg Shock Foam Infant Insert Infant Insert Egg Shock Pad FoamCanopy Vehicle Seat Belt Systems Bight Belt Forward Buckle FlipLap Belts With Retractor Lap or Shoulder Belt Mounted on Front Door fig. f Combination Lap/Shoulder Belt with Free Sliding Latch Plate Locking Clip stored in pouch on back of car seat Car seat is secure Additional Information Certification Warm WeatherCare and Cleaning Cleaning SeatRe-use After a Crash Registration Information Limited Warranty 8040 EN 122904.qxd 12/29/04 917 PM Designed by Parents, for Parents