Combi 8040 instruction manual Installation of Infant Car Seat in Vehicle

Page 19

8040 (EN) 122904.qxd 12/29/04 9:17 PM Page 19

Section 9 - Installation of Infant Car Seat in Vehicle

WARNING DEATH or SERIOUS INJURY can occur

Use only in a rear-facing position when using this infant car seat in a vehicle.

Secure this child restraint with the LATCH System or a vehicle seat belt as shown in this manual.

LATCH belt or vehicle seat belt must stay tightly adjusted around car seat or base at all times. If LATCH belt or vehicle seat belt does not stay tight, read the vehicle owner’s manual and “Vehicle Seat Belts” section in this manual.

Rear-facing car seat must be properly reclined:

-Too reclined can result in injury or ejection.

-Too upright can result in breathing difficulties.

After installing infant car seat in base, lift car seat to be sure it is securely locked.

18

Image 19
Contents Combi Connection Infant Car Seat 8040 EN 122904.qxd 12/29/04 917 PM 8040 EN 122904.qxd 12/29/04 917 PM Table of Contents Located on back of seat pad Carry Infant CAR Seat Connection Infant Car Seat PartsCAR Seat Base Proper Use Check List Use Recommendations Height and Weight LimitsSecuring Infant In Car Seat 8040 EN 122904.qxd 12/29/04 917 PM Fig. a Click fig. b Rolled Towel See Harness Use and Adjustment sectionSelecting a Vehicle Seating Location Options For Securing a Car Seat Latch System On This Car Seat Latch SystemLatch System On Vehicles Fig. c Installation of Infant Car Seat in Vehicle Attaching Infant Car Seat To Base Removal Of Infant Car Seat From BaseStriped Zone Recline Indicator LineSecuring Base With Latch System LowerButton Anchor Belt Anchor ConnectorsStriped Zone GreenFig. f Repeat for connector on opposite sideRemoval Of Base Installed With Latch Anchor Connector Storage Of Lower Anchorage Belt And Lower Anchor ConnectorsSecuring Base With Vehicle Seat Belt Fig. b Recline Indicator Down over outside of blue belt guide 4 fig. d Fig. e Securing Infant Car Seat Without Base Fig. b Green Striped Zone Fig. d Belt Guide ShoulderRemoval Of Infant Car Seat From Vehicle Stroller or Travel System Use Harness Use and Adjustment Operation and AdjustmentUnder Shoulder Harness Loops Changing Use Position and Harness LengthShoulder Harness Under Adjuster CoverShoulder Harness Loop Tab Changing Shoulder Harness Slot Position Fig. d Adjustment Button Adjuster Handle Base AdjustmentEgg Shock Foam Infant Insert Egg Shock Pad Foam Infant InsertCanopy Vehicle Seat Belt Systems Flip Bight Belt Forward BuckleLap Belts With Retractor Lap or Shoulder Belt Mounted on Front Door fig. f Combination Lap/Shoulder Belt with Free Sliding Latch Plate Locking Clip stored in pouch on back of car seat Car seat is secure Certification Warm Weather Additional InformationCleaning Seat Care and CleaningRe-use After a Crash Registration Information Limited Warranty 8040 EN 122904.qxd 12/29/04 917 PM Designed by Parents, for Parents