Graco 311511G important safety instructions Power Jumper Location, Terminal Blocks

Page 16

Setup

Step Two - Reposition Power Jumpers

Find location of Power Jumpers.

Power Jumper

Location

ti8609a

For 230V, 1 Phase and 230V, 3 Phase Installations, change jumper positions as shown below. Machine is shipped with jumpers in the fail-safe 380 3Ø position.

1.Remove upper rear control cover screws and cover.

2.Move one red jumper from the storage positions to the positions shown for your power.

•A flat-blade screwdriver can be used under the ridge on the side of the jumper to remove them.

•Push the jumper firmly into the new position.

3.Replace rear cover and two screws.

Step Two

TB2

Terminal Blocks

Position red jumpers (under back cover on opposite side)

, , , .

6 679%

(as shipped)

, , , .

6 6$ELTA

, , , .

6

ti8610a

16

311511G

Image 16

Contents Reactor A-20 Contents Related ManualsSystems Proportioner 50 ft 15 m 10 ft 3 mPart ApprovalsElectric Shock Hazard Fire and Explosion Hazard Moving Parts Hazard Typical Installation, without Circulation Key for FIGTypical Installation, with Circulation Moisture Sensitivity of Isocyanates Foam Self-IgnitionIsocyanate Hazard Keep Components a and B SeparateTypical Installation Component IdentificationKey Controls and Indicators AP Park/Run SwitchPressure Relief Procedure FlushingDetermine Power Source SetupLocate Reactor A-20 Electrical Requirements Configure to Supply Power Step One Connect Electrical CordPower Jumper Location Terminal BlocksIso Pump Lubrication System Setup Ground SystemFluid Supply Connections Air Supply ConnectionConnect FTS and Heated Dual Whip Hose Recirculation / Pressure Relief Lines Connect Heated HoseConnect Whip Hose to Gun Fluid Manifold Close Gun Fluid Manifold Valves a and BPressure Check Hose Initial Startup Fluid Temperature Sensor FTS CalibrationLoad Fluid with Feed Pumps To change or enter the set point, proceed as follows Digital Temperature ControllersA1 A2 A3 To change to Celsius units To change back to Fahrenheit unitsFluid Heater Temperature Offset Over Temperature AlarmsHose Heat Manual Mode Supply Wet-Cups with Throat Seal Liquid Spraying Setup SpraySpray Adjustments Shutdown Daily Start-up Procedure OperationTi2414A Fluid Circulation Circulation Through ReactorCirculation Through Gun Manifold CKNMaintenance Technical Data Category DataTechnical Data 311511G Graco Standard Warranty Graco Information