Graco 311511G To change to Celsius units, To change back to Fahrenheit units

Page 23

Initial Startup

Change Between Fahrenheit and Celsius

The temperature controller is factory-set to display in

Fahrenheit units.

To change to Celsius units:

1.Press and release Scroll button (A1) until Controller displays “UNIT”.

2.Press and release Down button (A3) once to display “F”.

3.Press and release Down button (A3) once again to display “C”.

4.Press and release Scroll button (A1) twice. Controller will display Celsius units.

To change back to Fahrenheit units:

1.Press and release Scroll button (A1) until Controller displays “UNIT”.

2.Press and release Down button (A3) once to display “C”.

3.Press and release Down button (A3) once again to display “F”.

4.Press and release Scroll button (A1) twice. Controller will display Fahrenheit units.

311511G

23

Image 23

Contents Reactor A-20 Related Manuals ContentsApprovals SystemsProportioner 50 ft 15 m 10 ft 3 m PartElectric Shock Hazard Fire and Explosion Hazard Moving Parts Hazard Key for FIG Typical Installation, without CirculationTypical Installation, with Circulation Keep Components a and B Separate Moisture Sensitivity of IsocyanatesFoam Self-Ignition Isocyanate HazardComponent Identification Typical InstallationKey AP Park/Run Switch Controls and IndicatorsFlushing Pressure Relief ProcedureLocate Reactor A-20 Electrical Requirements SetupDetermine Power Source Step One Connect Electrical Cord Configure to Supply PowerTerminal Blocks Power Jumper LocationAir Supply Connection Iso Pump Lubrication System SetupGround System Fluid Supply ConnectionsConnect FTS and Heated Dual Whip Hose Connect Heated Hose Recirculation / Pressure Relief LinesPressure Check Hose Close Gun Fluid Manifold Valves a and BConnect Whip Hose to Gun Fluid Manifold Load Fluid with Feed Pumps Fluid Temperature Sensor FTS CalibrationInitial Startup A1 A2 A3 Digital Temperature ControllersTo change or enter the set point, proceed as follows To change back to Fahrenheit units To change to Celsius unitsHose Heat Manual Mode Over Temperature AlarmsFluid Heater Temperature Offset Supply Wet-Cups with Throat Seal Liquid Spray Spraying SetupSpray Adjustments Shutdown Operation Daily Start-up ProcedureTi2414A Circulation Through Reactor Fluid CirculationCKN Circulation Through Gun ManifoldMaintenance Category Data Technical DataTechnical Data 311511G Graco Information Graco Standard Warranty