Graco 311511G Close Gun Fluid Manifold Valves a and B, Connect Whip Hose to Gun Fluid Manifold

Page 20

Setup

Close Gun Fluid Manifold Valves A and B

ti2411a

Connect Whip Hose to Gun Fluid Manifold

Do not connect manifold to gun.

ti2417a

Pressure Check Hose

See hose manual. Pressure check for leaks. If no leaks, wrap hose and electrical connections to protect from damage.

20

311511G

Image 20

Contents Reactor A-20 Contents Related ManualsSystems Proportioner 50 ft 15 m 10 ft 3 mPart ApprovalsElectric Shock Hazard Fire and Explosion Hazard Moving Parts Hazard Typical Installation, without Circulation Key for FIGTypical Installation, with Circulation Moisture Sensitivity of Isocyanates Foam Self-IgnitionIsocyanate Hazard Keep Components a and B SeparateTypical Installation Component IdentificationKey Controls and Indicators AP Park/Run SwitchPressure Relief Procedure FlushingLocate Reactor A-20 Electrical Requirements SetupDetermine Power Source Configure to Supply Power Step One Connect Electrical CordPower Jumper Location Terminal BlocksIso Pump Lubrication System Setup Ground SystemFluid Supply Connections Air Supply ConnectionConnect FTS and Heated Dual Whip Hose Recirculation / Pressure Relief Lines Connect Heated HosePressure Check Hose Close Gun Fluid Manifold Valves a and BConnect Whip Hose to Gun Fluid Manifold Load Fluid with Feed Pumps Fluid Temperature Sensor FTS CalibrationInitial Startup A1 A2 A3 Digital Temperature ControllersTo change or enter the set point, proceed as follows To change to Celsius units To change back to Fahrenheit unitsHose Heat Manual Mode Over Temperature AlarmsFluid Heater Temperature Offset Supply Wet-Cups with Throat Seal Liquid Spraying Setup SpraySpray Adjustments Shutdown Daily Start-up Procedure OperationTi2414A Fluid Circulation Circulation Through ReactorCirculation Through Gun Manifold CKNMaintenance Technical Data Category DataTechnical Data 311511G Graco Standard Warranty Graco Information