Graco 311511G important safety instructions Shutdown

Page 28

Shutdown

Shutdown

1. Shut off Primary and Hose heat switches.

34!24

/.

/&&

2.Park component A pump. Turn PARK/RUN switch to PARK.

3.Follow Pressure Relief procedure; see page 13.

4.Turn Pump Mode Function knob to OFF.

34!24

/.

/&&

5.Turn Main Power Disconnect switch (R) OFF.

6.Close air inlet ball valve (DD) and fluid inlet valves (X, U).

7.Check and fill wet-cups (AK, Z).

8.Follow gun shutdown procedure.

28

311511G

Image 28
Contents Reactor A-20 Contents Related ManualsSystems Proportioner 50 ft 15 m 10 ft 3 mPart ApprovalsElectric Shock Hazard Fire and Explosion Hazard Moving Parts Hazard Typical Installation, without Circulation Key for FIGTypical Installation, with Circulation Moisture Sensitivity of Isocyanates Foam Self-IgnitionIsocyanate Hazard Keep Components a and B SeparateTypical Installation Component IdentificationKey Controls and Indicators AP Park/Run SwitchPressure Relief Procedure FlushingDetermine Power Source SetupLocate Reactor A-20 Electrical Requirements Configure to Supply Power Step One Connect Electrical CordPower Jumper Location Terminal BlocksIso Pump Lubrication System Setup Ground SystemFluid Supply Connections Air Supply ConnectionConnect FTS and Heated Dual Whip Hose Recirculation / Pressure Relief Lines Connect Heated HoseConnect Whip Hose to Gun Fluid Manifold Close Gun Fluid Manifold Valves a and BPressure Check Hose Initial Startup Fluid Temperature Sensor FTS CalibrationLoad Fluid with Feed Pumps To change or enter the set point, proceed as follows Digital Temperature ControllersA1 A2 A3 To change to Celsius units To change back to Fahrenheit unitsFluid Heater Temperature Offset Over Temperature AlarmsHose Heat Manual Mode Supply Wet-Cups with Throat Seal Liquid Spraying Setup SpraySpray Adjustments Shutdown Daily Start-up Procedure OperationTi2414A Fluid Circulation Circulation Through ReactorCirculation Through Gun Manifold CKNMaintenance Technical Data Category DataTechnical Data 311511G Graco Standard Warranty Graco Information