Graco 311511G important safety instructions Ti2414A

Page 30

Operation

16. Open gun fluid manifold valves A and B.

ti2414A

17. Disengage gun piston safety lock.

ti2410A

18.Test spray onto cardboard.

19.Observe isocyanate-A and resin-B gauges on up and down strokes. Readjust upstroke pressure regulator as required to ensure proportioning pump pressure is equal on both the up and down strokes.

20.Equipment is ready to spray.

311511G

Image 30

Contents Reactor A-20 Contents Related ManualsPart SystemsProportioner 50 ft 15 m 10 ft 3 m ApprovalsElectric Shock Hazard Fire and Explosion Hazard Moving Parts Hazard Typical Installation, without Circulation Key for FIGTypical Installation, with Circulation Isocyanate Hazard Moisture Sensitivity of IsocyanatesFoam Self-Ignition Keep Components a and B SeparateTypical Installation Component IdentificationKey Controls and Indicators AP Park/Run SwitchPressure Relief Procedure FlushingSetup Determine Power SourceLocate Reactor A-20 Electrical Requirements Configure to Supply Power Step One Connect Electrical CordPower Jumper Location Terminal BlocksFluid Supply Connections Iso Pump Lubrication System SetupGround System Air Supply ConnectionConnect FTS and Heated Dual Whip Hose Recirculation / Pressure Relief Lines Connect Heated HoseClose Gun Fluid Manifold Valves a and B Connect Whip Hose to Gun Fluid ManifoldPressure Check Hose Fluid Temperature Sensor FTS Calibration Initial StartupLoad Fluid with Feed Pumps Digital Temperature Controllers To change or enter the set point, proceed as followsA1 A2 A3 To change to Celsius units To change back to Fahrenheit unitsOver Temperature Alarms Fluid Heater Temperature OffsetHose Heat Manual Mode Supply Wet-Cups with Throat Seal Liquid Spraying Setup SpraySpray Adjustments Shutdown Daily Start-up Procedure OperationTi2414A Fluid Circulation Circulation Through ReactorCirculation Through Gun Manifold CKNMaintenance Technical Data Category DataTechnical Data 311511G Graco Standard Warranty Graco Information