CONNECTIONS
Connecting a Video Component
DVD/LD player |
|
| TV/digital TV, satellite tuner, cable TV | ||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
ANALOG | VIDEO | COAXIAL | OPTICAL | OPTICAL | VIDEO | ANALOG | |||||
AUDIO OUT | OUT | DIGITAL OUT | DIGITAL OUT | DIGITAL OUT | OUT | AUDIO OUT | |||||
L | R | V | C |
O
(Europe model)
O
V |
L | R |
L | R |
AUDIO OUT
L | R |
AUDIO IN
|
| V |
|
| R |
|
| L |
|
| No connection |
V | V | |
VIDEO |
| VIDEO |
OUT |
| IN |
L 
R 
V
V
O 
VIDEO
IN
C 
Analog signal
Video signal
Digital signal (optical)
Digital signal (coaxial)
Signal flow
PREPARATION
VCR | TV monitor |
■Audio signal terminals
Be sure to connect the right channel (R), left channel (L), input (IN) and output (OUT) properly.
■Video signal terminals
Be sure to connect the input (IN) and output (OUT) properly.
■Digital audio signal terminals
If your DVD/LD player, TV/digital TV or satellite tuner, etc. has coaxial or optical digital signal output terminals, they can be connected to this unit’s COAXIAL and/or OPTICAL digital signal input terminals. To make a connection between the optical digital signal terminals, remove the cover from each terminal, and then connect them by using a commercially available optical fiber cable that conforms to EIA standards. Other cables might not function correctly.
When making connections between the digital signal terminals, you should connect the components to the same- named analog audio signal terminals of this unit, because a digital signal cannot be recorded by a tape deck, MD recorder or VCR connected to this unit.
■TV monitor with a 21-pin connector
Make a connection as shown above with a commercially available
Notes
•Be sure to attach the covers when the OPTICAL terminals are not being used in order to protect them from dust.
•If your LD player has a Dolby Digital RF signal output terminal, be sure to use the RF demodulator (separately purchased).
•No sound will be heard when connecting your LD player’s Dolby Digital RF signal output terminal directly to this unit’s COAXIAL DVD/LD digital signal input terminal.
y
•The input signal from the DVD/LD input terminals is selected in
the following order of priority with the input mode set to AUTO: COAXIAL terminal → OPTICAL terminal → Analog terminal.
Refer to page 22 for details.
•All digital signal input terminals are applicable to sampling frequencies of 32 kHz, 44.1 kHz and 48 kHz.
English
13