Pelco IP110 Varifocal Lens Zoom and Focus Adjustments, Location of Zoom and Focus Locking Screws

Page 22

VARIFOCAL LENS ZOOM AND FOCUS ADJUSTMENTS

NOTE: You will need a miniature Phillips or flat-tip screwdriver to loosen and tighten the locking screws.

To adjust the field of view:

1.Loosen the zoom locking screw (refer to Figure 15).

2.Turn the zoom adjustment ring clockwise or counterclockwise to select the field of view.

3.Tighten the zoom locking screw.

FOCUS

ZOOM

Figure 15. Location of Zoom and Focus Locking Screws

22	C3432M-G (4/09)

Image 22

Contents IP110 Series Camclosure Page Contents List of Illustrations List of Tables Important Safety Instructions Regulatory Notices Radio and Television InterferenceOpen Source Software Notice Description Parts ListModels Basic System Configurations Dhcp Network ExamplePrivate Network Example Cover and Back Box Installation Basic Surface Installation4S Electrical BOX Installation Electrical Box InstallationPlaster Ring Installation Plaster Ring InstallationSide Conduit Installation Side Conduit InstallationRefer to for pin descriptions Wiring TablesCAT5 Cable PoEAlarm and 24 VAC Wires Connecting Alarms Camera Module Camera OrientationModule Installation Camera Module BracketCamera Adjustments To perform camera adjustmentsVarifocal Lens Zoom and Focus Adjustments Location of Zoom and Focus Locking ScrewsTo adjust the focus Loosen the focus locking screw Adjusting the FocusDN/CH Series Adjustments Refer to to adjust the IP110-DN or IP110-CH modelBlemish Detection DAY/NIGHT Operation DW/CW Series Wide Dynamic Range Adjustments Refer to to adjust the IP110-DW or IP110-CW modelSW1-4 Auto White Balance/Manual White Balance Auto Iris Level Adjustment Camera Positioning Positioning the CameraInstall Dome and Trim Ring Service Connector Service ConnectorAttaching the 2.5 mm Monaural Headphone Plug Reset Button Troubleshooting Green LED during camera power up Table F. Troubleshooting the IP110 Series 2IR cut filter setting Check DIP switch settings IR cut filter is functioningConfiguration Table F. Troubleshooting the IP110 Series 3Network not Faulty cable Router with an n-Port switchCable Entry SpecificationsImpact Cm openings on Nema coverSignal System Ntsc or PAL Scanning System Signal System176 x Bit Rate Configurable 704 xLens TypeC3432M-G 4/09 Revision History Product Warranty and Return Information