Pelco Table F. Troubleshooting the IP110 Series 3, Network not Faulty cable, Configuration

Table F. Troubleshooting the IP110 Series (3 of 3)

Problem	Possible Cause	Suggested Remedy
Network not	Faulty cable	Check all cable connections and ensure all plugs are
working	connection	properly plugged in.
	Incorrect serial device	A hub will not work with the available network
	configuration	bandwidth shared across all ports. Use a Fast Ethernet
		switch, Gigabit Ethernet switch, or a cable modem
		router with an n-Port switch.
	Network connectivity	Contact your network administrator.
	issues
Unable to sync	Network connectivity	• Disconnect the power cable (either PoE or 24 VAC)
to an Endura®	issues	and then reconnect it to the camera. Power is
system manager		indicated by the LED. The LED will flash (green) five
or NTP server		times per second for approximately two minutes if
after changing		the camera has power.
networks		• Reset the camera’s factory defaults (refer to Reset
		Button on page 34).

C3432M-G (4/09) 37