Pelco IP110 manual Open Source Software Notice

Page 8

Open Source Software Notice

This product includes certain open source or other software originated from third parties that is subject to the GNU General Public License (GPL), GNU Library/Lesser General Public License (LGPL), and different and/or additional copyright licenses, disclaimers, and notices.

The exact terms of GPL, LGPL, and some other licenses are provided to you with this product. Please refer to the exact terms of the GPL and LGPL at http://www.fsf.org (Free Software Foundation) or http://www.opensource.org (Open Source Initiative) regarding your rights under said license. You may obtain a complete corresponding machine-readable copy of the source code of such software under the GPL or LGPL by sending your request to digitalsupport@pelco.com; the subject line should read Source Code Request. You will then receive an e-mail with a link for you to download the source code.

This offer is valid for a period of three (3) years from the date of the distribution of this product by Pelco.

WARNING: This product is sensitive to Electrostatic Discharge (ESD). To avoid ESD damage to this product, use ESD safe practices during installation. Before touching, adjusting or handling this product, correctly attach an ESD wrist strap to your wrist and appropriately discharge your body and tools. For more information about ESD control and safe handling practices of electronics, please refer to ANSI/ESD S20.20- 1999 or contact the Electrostatic Discharge Association (www.esda.org).

The materials used in the manufacture of this document and its components are compliant to the requirements of Directive 2002/95/EC.

This equipment contains electrical or electronic components that must be recycled properly to comply with Directive 2002/96/EC of the European Union regarding the disposal of waste electrical and electronic equipment (WEEE). Contact your local dealer for procedures for recycling this equipment.

8

C3432M-G (4/09)

Image 8
Contents IP110 Series Camclosure Page Contents List of Illustrations List of Tables Important Safety Instructions Regulatory Notices Radio and Television InterferenceOpen Source Software Notice Models Parts ListDescription Basic System Configurations Dhcp Network ExamplePrivate Network Example Cover and Back Box Installation Basic Surface Installation4S Electrical BOX Installation Electrical Box InstallationPlaster Ring Installation Plaster Ring InstallationSide Conduit Installation Side Conduit InstallationWiring Tables CAT5 CableRefer to for pin descriptions PoEAlarm and 24 VAC Wires Connecting Alarms Camera Module Camera OrientationModule Installation Camera Module BracketCamera Adjustments To perform camera adjustmentsVarifocal Lens Zoom and Focus Adjustments Location of Zoom and Focus Locking ScrewsTo adjust the focus Loosen the focus locking screw Adjusting the FocusDN/CH Series Adjustments Refer to to adjust the IP110-DN or IP110-CH modelBlemish Detection DAY/NIGHT Operation DW/CW Series Wide Dynamic Range Adjustments Refer to to adjust the IP110-DW or IP110-CW modelSW1-4 Auto White Balance/Manual White Balance Auto Iris Level Adjustment Camera Positioning Positioning the CameraInstall Dome and Trim Ring Service Connector Service ConnectorAttaching the 2.5 mm Monaural Headphone Plug Reset Button Troubleshooting Table F. Troubleshooting the IP110 Series 2 IR cut filter setting Check DIP switch settingsGreen LED during camera power up IR cut filter is functioningTable F. Troubleshooting the IP110 Series 3 Network not Faulty cableConfiguration Router with an n-Port switchSpecifications ImpactCable Entry Cm openings on Nema coverSignal System 176 x Bit Rate ConfigurableSignal System Ntsc or PAL Scanning System 704 xLens TypeC3432M-G 4/09 Revision History Product Warranty and Return Information