Pelco manual DN/CH Series Adjustments, Refer to to adjust the IP110-DN or IP110-CH model

Page 24

DN/CH SERIES ADJUSTMENTS

Refer to Figure 17 to adjust the IP110-DN or IP110-CH model.

Figure 17. Adjusting the IP110-DN/CH Series Camclosure

SWITCH SETTINGS

Locate the DIP switch. Then set the switches for your installation.

SW4-1: Auto Gain Control

The automatic gain control (AGC) adjusts the image automatically to compensate for changes in light levels.

Set SW4-1 to ON to enable AGC. Set it to OFF to disable AGC. The default setting is ON.

SW4-2: Backlight Compensation

The backlight compensation (BLC) feature compensates for backlit scenes by enhancing objects in the center of the scene.

Set SW4-2 to ON to enable BLC. Use this setting if a bright backlight is present and the subject in the center of the picture appears dark or as a silhouette.

Set it to OFF to disable backlight compensation. This is the default setting.

SW4-3: N/A

24	C3432M-G (4/09)

Image 24

Contents IP110 Series Camclosure Page Contents List of Illustrations List of Tables Important Safety Instructions Regulatory Notices Radio and Television InterferenceOpen Source Software Notice Parts List DescriptionModels Basic System Configurations Dhcp Network ExamplePrivate Network Example Cover and Back Box Installation Basic Surface Installation4S Electrical BOX Installation Electrical Box InstallationPlaster Ring Installation Plaster Ring InstallationSide Conduit Installation Side Conduit InstallationWiring Tables CAT5 CableRefer to for pin descriptions PoEAlarm and 24 VAC Wires Connecting Alarms Camera Module Camera OrientationModule Installation Camera Module BracketCamera Adjustments To perform camera adjustmentsVarifocal Lens Zoom and Focus Adjustments Location of Zoom and Focus Locking ScrewsTo adjust the focus Loosen the focus locking screw Adjusting the FocusDN/CH Series Adjustments Refer to to adjust the IP110-DN or IP110-CH modelBlemish Detection DAY/NIGHT Operation DW/CW Series Wide Dynamic Range Adjustments Refer to to adjust the IP110-DW or IP110-CW modelSW1-4 Auto White Balance/Manual White Balance Auto Iris Level Adjustment Camera Positioning Positioning the CameraInstall Dome and Trim Ring Service Connector Service ConnectorAttaching the 2.5 mm Monaural Headphone Plug Reset Button Troubleshooting Table F. Troubleshooting the IP110 Series 2 IR cut filter setting Check DIP switch settingsGreen LED during camera power up IR cut filter is functioningTable F. Troubleshooting the IP110 Series 3 Network not Faulty cableConfiguration Router with an n-Port switchSpecifications ImpactCable Entry Cm openings on Nema coverSignal System 176 x Bit Rate ConfigurableSignal System Ntsc or PAL Scanning System 704 xLens TypeC3432M-G 4/09 Revision History Product Warranty and Return Information