Pelco IP110 manual DW/CW Series Wide Dynamic Range Adjustments

Page 27

DW/CW SERIES (WIDE DYNAMIC RANGE) ADJUSTMENTS

Refer to Figure 19 to adjust the IP110-DW or IP110-CW model.

SW1

DEFAULT SWITCH POSITION

R7

Figure 19. Adjusting the IP110-DW/CW Series Camclosure

SWITCH SETTINGS

Locate the DIP switch. Then set the switches for your installation.

SW1-1: Video Format

Set SW1-1 to ON for NTSC. Set it to OFF for PAL. The default setting is ON.

SW1-2: N/A

SW1-3: Interlaced Scanning/Progressive Scanning

Interlaced scanning is the standard for analog recording installations. Each frame contains one odd and one even field, each processed separately.

Progressive scanning is better for digital recording installations. Each frame is processed as a whole, which results in less blurring and cleaner digital conversion. It also saves storage space on digital video recorders.

Set SW1-3 to ON to select interlaced scanning.

Set it to OFF to select progressive scanning. The default setting is ON.

C3432M-G (4/09)

27

Image 27
Contents IP110 Series Camclosure Page Contents List of Illustrations List of Tables Important Safety Instructions Radio and Television Interference Regulatory NoticesOpen Source Software Notice Parts List DescriptionModels Dhcp Network Example Basic System ConfigurationsPrivate Network Example Basic Surface Installation Cover and Back Box InstallationElectrical Box Installation 4S Electrical BOX InstallationPlaster Ring Installation Plaster Ring InstallationSide Conduit Installation Side Conduit InstallationPoE Wiring TablesCAT5 Cable Refer to for pin descriptionsAlarm and 24 VAC Wires Connecting Alarms Camera Orientation Camera ModuleCamera Module Bracket Module InstallationTo perform camera adjustments Camera AdjustmentsLocation of Zoom and Focus Locking Screws Varifocal Lens Zoom and Focus AdjustmentsAdjusting the Focus To adjust the focus Loosen the focus locking screwRefer to to adjust the IP110-DN or IP110-CH model DN/CH Series AdjustmentsBlemish Detection DAY/NIGHT Operation Refer to to adjust the IP110-DW or IP110-CW model DW/CW Series Wide Dynamic Range AdjustmentsSW1-4 Auto White Balance/Manual White Balance Auto Iris Level Adjustment Positioning the Camera Camera PositioningInstall Dome and Trim Ring Service Connector Service ConnectorAttaching the 2.5 mm Monaural Headphone Plug Reset Button Troubleshooting IR cut filter is functioning Table F. Troubleshooting the IP110 Series 2IR cut filter setting Check DIP switch settings Green LED during camera power upRouter with an n-Port switch Table F. Troubleshooting the IP110 Series 3Network not Faulty cable ConfigurationCm openings on Nema cover SpecificationsImpact Cable Entry704 x Signal System176 x Bit Rate Configurable Signal System Ntsc or PAL Scanning SystemType LensC3432M-G 4/09 Revision History Product Warranty and Return Information