Pelco IP110 manual Module Installation, Camera Module Bracket

Page 20

MODULE INSTALLATION

To install the camera module into the back box:

1.Plug the camera (10-pin), heater board (4-pin), and service (3-pin) connectors into the back box (refer to Figure 13).

HEATER

CONNECTOR

SERVICE

CONNECTOR

CAMERA

CONNECTOR

Figure 13. Back Box Connectors

2.Make sure the tabs on the camera bracket and the service connector are pointing out of the enclosure and away from the ceiling or wall.

3.Gently squeeze the bracket, place it against the groove inside the back box, and then gently release (refer to Figure 14).

BRACKET

Figure 14. Camera Module Bracket

20

C3432M-G (4/09)

Image 20
Contents IP110 Series Camclosure Page Contents List of Illustrations List of Tables Important Safety Instructions Regulatory Notices Radio and Television InterferenceOpen Source Software Notice Models Parts ListDescription Basic System Configurations Dhcp Network ExamplePrivate Network Example Cover and Back Box Installation Basic Surface Installation4S Electrical BOX Installation Electrical Box InstallationPlaster Ring Installation Plaster Ring InstallationSide Conduit Installation Side Conduit InstallationWiring Tables CAT5 CableRefer to for pin descriptions PoEAlarm and 24 VAC Wires Connecting Alarms Camera Module Camera OrientationModule Installation Camera Module BracketCamera Adjustments To perform camera adjustmentsVarifocal Lens Zoom and Focus Adjustments Location of Zoom and Focus Locking ScrewsTo adjust the focus Loosen the focus locking screw Adjusting the FocusDN/CH Series Adjustments Refer to to adjust the IP110-DN or IP110-CH modelBlemish Detection DAY/NIGHT Operation DW/CW Series Wide Dynamic Range Adjustments Refer to to adjust the IP110-DW or IP110-CW modelSW1-4 Auto White Balance/Manual White Balance Auto Iris Level Adjustment Camera Positioning Positioning the CameraInstall Dome and Trim Ring Service Connector Service ConnectorAttaching the 2.5 mm Monaural Headphone Plug Reset Button Troubleshooting Table F. Troubleshooting the IP110 Series 2 IR cut filter setting Check DIP switch settingsGreen LED during camera power up IR cut filter is functioningTable F. Troubleshooting the IP110 Series 3 Network not Faulty cableConfiguration Router with an n-Port switchSpecifications ImpactCable Entry Cm openings on Nema coverSignal System 176 x Bit Rate ConfigurableSignal System Ntsc or PAL Scanning System 704 xLens TypeC3432M-G 4/09 Revision History Product Warranty and Return Information