Pelco IP110 manual DAY/NIGHT Operation

Page 26

DAY/NIGHT OPERATION

NOTE: This section only applies to DN model cameras.

DN model cameras regularly check the brightness level of the field of view to determine when to switch between day (color) and night (black-white) operation.

Actual brightness threshold levels are affected by camera angle, amount of zoom, field of view, lens, and type of lighting. The switching process lasts from seven to 10 seconds.

Figure 20 and Table C show how the camera switches between color and black-white operation.

FALLING LIGHT LEVEL

COLOR MODE

B-W MODE

3.0lux

1.5lux

COLOR MODE

B-W MODE

RISING LIGHT LEVEL

Figure 18. DN Models Threshold Switching Levels

Table C. DN Models Switching Thresholds

Color to B-W

1.5 lux ±1.0 lux

B-W to Color

3.0 lux ±1.0 lux

 

 

NOTE: These switching thresholds are approximate. Use the thresholds in Table C as a guide when installing the unit.

26

C3432M-G (4/09)

Image 26
Contents IP110 Series Camclosure Page Contents List of Illustrations List of Tables Important Safety Instructions Regulatory Notices Radio and Television InterferenceOpen Source Software Notice Models Parts ListDescription Basic System Configurations Dhcp Network ExamplePrivate Network Example Cover and Back Box Installation Basic Surface Installation4S Electrical BOX Installation Electrical Box InstallationPlaster Ring Installation Plaster Ring InstallationSide Conduit Installation Side Conduit InstallationRefer to for pin descriptions Wiring TablesCAT5 Cable PoEAlarm and 24 VAC Wires Connecting Alarms Camera Module Camera OrientationModule Installation Camera Module BracketCamera Adjustments To perform camera adjustmentsVarifocal Lens Zoom and Focus Adjustments Location of Zoom and Focus Locking ScrewsTo adjust the focus Loosen the focus locking screw Adjusting the FocusDN/CH Series Adjustments Refer to to adjust the IP110-DN or IP110-CH modelBlemish Detection DAY/NIGHT Operation DW/CW Series Wide Dynamic Range Adjustments Refer to to adjust the IP110-DW or IP110-CW modelSW1-4 Auto White Balance/Manual White Balance Auto Iris Level Adjustment Camera Positioning Positioning the CameraInstall Dome and Trim Ring Service Connector Service ConnectorAttaching the 2.5 mm Monaural Headphone Plug Reset Button Troubleshooting Green LED during camera power up Table F. Troubleshooting the IP110 Series 2IR cut filter setting Check DIP switch settings IR cut filter is functioningConfiguration Table F. Troubleshooting the IP110 Series 3Network not Faulty cable Router with an n-Port switchCable Entry SpecificationsImpact Cm openings on Nema coverSignal System Ntsc or PAL Scanning System Signal System176 x Bit Rate Configurable 704 xLens TypeC3432M-G 4/09 Revision History Product Warranty and Return Information