Pelco IP110 manual Camera Positioning, Positioning the Camera

Page 30

Camera Positioning

Manually rotate and tilt the camera module to position the camera, and then tighten the tilt screws (axis 1 in Figure 21).

NOTE: Do not over-rotate the module. Excessively turning the module in one direction could result in damage to the wiring.

ìTilt 80° (20° to 100°)

îPan 360°

ïRotation 360°

Figure 21. Positioning the Camera

30	C3432M-G (4/09)

Image 30

Contents IP110 Series Camclosure Page Contents List of Illustrations List of Tables Important Safety Instructions Regulatory Notices Radio and Television InterferenceOpen Source Software Notice Parts List DescriptionModels Basic System Configurations Dhcp Network ExamplePrivate Network Example Cover and Back Box Installation Basic Surface Installation4S Electrical BOX Installation Electrical Box InstallationPlaster Ring Installation Plaster Ring InstallationSide Conduit Installation Side Conduit InstallationRefer to for pin descriptions Wiring TablesCAT5 Cable PoEAlarm and 24 VAC Wires Connecting Alarms Camera Module Camera OrientationModule Installation Camera Module BracketCamera Adjustments To perform camera adjustmentsVarifocal Lens Zoom and Focus Adjustments Location of Zoom and Focus Locking ScrewsTo adjust the focus Loosen the focus locking screw Adjusting the FocusDN/CH Series Adjustments Refer to to adjust the IP110-DN or IP110-CH modelBlemish Detection DAY/NIGHT Operation DW/CW Series Wide Dynamic Range Adjustments Refer to to adjust the IP110-DW or IP110-CW modelSW1-4 Auto White Balance/Manual White Balance Auto Iris Level Adjustment Camera Positioning Positioning the CameraInstall Dome and Trim Ring Service Connector Service ConnectorAttaching the 2.5 mm Monaural Headphone Plug Reset Button Troubleshooting Green LED during camera power up Table F. Troubleshooting the IP110 Series 2IR cut filter setting Check DIP switch settings IR cut filter is functioningConfiguration Table F. Troubleshooting the IP110 Series 3Network not Faulty cable Router with an n-Port switchCable Entry SpecificationsImpact Cm openings on Nema coverSignal System Ntsc or PAL Scanning System Signal System176 x Bit Rate Configurable 704 xLens TypeC3432M-G 4/09 Revision History Product Warranty and Return Information