Pelco C3412M-D manual Aux, Back Exit AUX AUX 1 Mode Toggle Dwell Time Secs AUX 2 Mode

Page 71

AUX

SPECTRA IV

LANGUAGE

<SYSTEM INFORMATION> <DISPLAY SETUP>

<DOME SETTINGS>

ACK ALERT*

RESET CAMERA

CYCLE CAMERA POWER

REBOOT SYSTEM

EXIT

DOME SETTINGS

<CAMERA>

<MOTION> <POWER UP> <LINE SYNC> <PRESETS> <PATTERNS> <ZONES>

<WINDOW BLANKING> <ALARMS>

<AUX>

<TITLE TEXT> <ALERT>* <CLEAR> <PASSWORD> <CLOCK> <EVENT>

BACK

EXIT

AUX

AUX 1 MODE

TOGGLE

DWELL TIME (SECS)

1

AUX 2 MODE

TOGGLE

DWELL TIME (SECS)

1

<EDIT SCHEDULE>

 

BACK

 

EXIT

 

Note: If a 16X or 18X model dome drive is installed in a Spectra III SE or Spectra IV SE back box, the auxiliary feature is functional and available. If a 16X or 18X model is installed in a standard Spectra III or Spectra IV back box, the auxiliary feature is not available.

An auxiliary output is a programmable signal from the dome back box that can trigger another device to operate. An auxiliary output is programmable to trigger from an alarm or from a controller.

An AUX 1 command from the controller will activate the relay in the dome and operate the device that is connected to the relay. The output of AUX 1 can be connected to the alarm input of a system switch to activate automatic monitor switching and recording.

An AUX 2 command from the controller will place a ground at the output of AUX 2 to operate the device that is connected to it.

The following are the available AUX mode settings:

TOGGLE (default): Changes the state of the auxiliary output every time an AUX command is received from the controller.

LATCHING: Must receive an AUX ON/AUX OFF command from the controller to turn the auxiliary output on/off.

MOMENTARY: An AUX ON command from the controller turns the auxiliary output on for the programmed DWELL TIME. The auxiliary output will automatically turn off when the dwell time is finished.

EDIT SCHEDULE

The Edit Schedule menu is a duplicate of the Edit Event menu (refer to Event on page 80) with the following exceptions. In the Edit Schedule menu, the event type cannot be changed. Also, the Holiday feature cannot be accessed from the Edit Schedule menu.

For instructions on changing the features in the Edit Schedule menu, refer to Edit Event on page 83.

* This setting applies only to Pressurized Spectra IV dome systems.

C3412M-D (12/08)

71

Page 70 Page 72
Image 71
Page 70 Page 72
Contents Spectra IV and Spectra IV SE Series Page Contents Field Align Wide Dynamic RangeRepeat Ack Action Activate Aux Current Reading Reset Alert Welcome SW2 Switch 2 CM9502 Setting InstallationSwitch Settings SW2 Switch 1 AD-32 Preset SystemSW2 Switches 4-5 Serial Port Settings SW2 Switch 3 Control System CompatibilitySW2 Switches 6-8 Baud Settings Dome Drive InstallationTable A. Switch Settings for SW1 P-Type Control OFF Table B. Switch Settings for SW1 D-Type ControlTable B. Switch Settings for SW1 D-Type Control 100 106 141 176 211 246 Getting Started Operation How to Operate Your Dome SystemQuick Programming Guide Accessing Main Menu PresetCM9500 VCD5000 Endura Workstation16X LowLight Color Menu Tree AUX Dome SettingsLine Sync Presets Edit the Password Clock Event18X LowLight Day/Night Menu Tree Title Text Line Sync Presets PatternsAlarms AUX Edit the Password Clock22X EXview LowLight Color Menu Tree Line Sync Alarms Alarm Settings23X LowLight Day/Night Menu Tree Edit Detection Areas Patterns 35X LowLight Day/Night Menu Tree Edit Detection Areas Exit ACK Alert Reset CameraLanguage Spectra LanguageSystem Information DIP Switch InformationDIP Switch Information Address SW2 1 32 PRESETS. OFFRestore Factory Defaults Back Exit Display SetupExit Display Setup Preset Label XXX.XX Title Text Save and Exit Cancel and Exit HelpType of Lighting Dome SettingsExit Dome Settings Camera CameraBack Exit Camera Advanced Settings Back ExitZoom Limit LOW Light Limit Zoom SpeedApplies only to 18X, 23X, and 35X models IR CUT FilterAGC Limit Advanced Camera SettingsShutter Speed Back Exit Auto IrisAuto White Balance Gain B Gain Auto White Balance Auto SharpnessAuto Iris Level Auto Iris Peak Dome Settings ACK Alert Reset CameraBacklight Compensation BLC Video LevelField Align Sensor Scan ModeElectronic Image Stabilization LOW LUX Noise Reduction Image EnhancementApplies only to 23X and 35X models Wide Dynamic RangeProportional PAN Auto FlipBack Exit Motion Exit Dome Settings Camera Motion Power UPPark Time Scan Speed Preset Freeze FrameLimit Stops Azimuth Zero Back Exit Power UP Power UP Action Power UPPower UP Action Line Sync Back Exit Line Sync Line Sync PhaseModel Number of Stored Presets PresetsAbcdefghij Cancel Klmnopqrst Uvwxyz Space Back Exit Presets Preset NumberLabel for Preset Preset Number C3412M-D 12/08 Edit Detection Areas Enable Motion DetectionPresets Preset Number Preset not Defined Edit Schedule Clear Preset Clear Camera Settings Back ExitMotion Detection Areas Edit Schedule Activate AUX CommandAUX Time Back Exit Patterns PatternsPatterns Zones Zones SET Windows Back Exit Window BlankingBack Exit Window Blanking StyleClear Window Enable Window Reverse Clear Window Back ExitReverse Window Blank Tilt Angles Blank ALL ABOVE/BLANK ALL belowAlarms C3412M-D 12/08 Default Normally open Dwell Time Secs Edit Schedule Back Exit Back Exit AUX AUX 1 Mode Toggle Dwell Time Secs AUX 2 ModeAUX Edit Title Text Title TextBack Exit Title Text Repeat AlertCurrent Reading Reset AlertACK Action Activate AUXClear Back Exit Edit the Password PasswordBack Exit Password Clock END Date Month October DAY END Time Clock Time Base Internal ClockHour Month April DAYEND Date Month October Week Last DAY Sunday END Time Time Base Internal ClockMM/DD/YYYY Month April Week 1ST DAY SundayEvent Back Exit Reference Information Event TypeBack Exit Event Event Type Event Label HolidayEdit Event Label Event LabelEdit Event Event Label Event Active Event Time Event Type Preset Number Back ExitEdit Event Back Exit Event Event Type Event Label Edit Event LabelHoliday Clear EventList Event Month January DAY Back Exit Edit HolidayEdit Holiday Occurrence List Holidays Clear HolidayEvent Number Event Type Label Time Occurs Holiday Scheduled EventsReboot System Reset, Cycle Power, RebootReset Camera Cycle Camera PowerSoftware/Language File Upload Suggested Preventative Maintenance 16X Models SpecificationsDD4CBW18 18X ModelsDD4C22 22X ModelsDD4CBW23 23X ModelsDD4CBW23-X DD4CBW35 35X ModelsDD4CBW35-X Page Product Warranty and Return Information
Top Page Image Contents