Ricoh FV-G200B1 manual 16/38

Page 16

3.4.2Exposure Timing with the Positive Polarity Trigger Signal

Input Trigger signal

Trigger signal

(With Photocoupler delay)

Filtering *Note.1

Less than 30 CLK 5useconds

T1'

Exposure time

SUB

75 CLK

Exposure tim: T1' = Preset exposure time

SG

Note 1: The trigger signal will be removed by the filtering if the pulse width of the input trigger signal is less than 30 CLK. Please input a trigger signal with more than 31 CLK pulse width.

Note 2: The exposure will start 105 CLK after the rising edge of the trigger signal.

3.4.3Exposure Timing with the Negative Polarity Trigger Signal

Input Trigger signal

Trigger signal

(With Photocoupler delay

Filtering *Note.1

Less than 30 CLK 60 useconds

T1'

Exposure time

SUB

75 CLK

Exposure tim: T1' = Preset exposure time

SG

Note 1: The trigger signal will be removed by the filtering if the pulse width of the input trigger signal is less than 30 CLK. Please input a trigger signal with more than 31 CLK pulse width.

Note 2: The exposure will start 105 CLK after the rising edge of the trigger signal.

FV-G200B1

16/38

User’s Guide Rev. 1.02

 

Image 16
Contents GigE Vision VGA Monochrome CCD Camera FV-G200B1 FV-G200B1 User’s Guide RevTable of Contents Connector Specifications RJ45 ConnectorDC Iris Lens Connector Power-I/O ConnectorFV-G200B1 User’s Guide Rev Equivalent Circuit for the Input Pin of the I/O Connector Or equivalent connectorHorizontal Timing Vertical Timing Full Scanning2 1/2 Partial Scanning 3 1/4 Partial ScanningAOI Area of Interest Fval Lval SUBPixel Transferring Image Pulse Width Trigger Mode Normal ModeTiming Exposure Timing with the Positive Polarity Trigger Signal Input Trigger signalTrigger signal Trigger signal With Photocoupler delayEdge Preset Trigger Mode 14/38 15/38 16/38 Reset mode Communication Method Communication SettingsCommunication Format Name Descriptions 【Example Code】Reading the data from the command 00H Camera Control Command Camera Command List Device Code22/38 23/38 24/38 Descriptions of the Camera Control Commands Device code Underline settings are the factory default settings26/38 27/38 28/38 29/38 30/38 Descriptions of the Camera Commands Device code AGC32/38 33/38 34/38 GenICam Command / Camera Command Reference Table GenICam command Device Command Function2EH 37/38 38/38