Ricoh manual FV-G200B1 User’s Guide Rev

Page 5

Note: I/O-1 can be assigned only by F0H[3..0] and F1[3], and I/O-2 can be assigned only by F0H[7..4] and F1[4].

1)FrameTriggerWait

The user can check the camera condition (camera exposure and image output processing by the trigger signal with this FrameTriggerWait signal).

This signal is LOW for the period from the trigger input signal to the image output.

a)High status (3.3V): No processing by the trigger signal. The camera accepts the trigger signal.

b)Low status (0V): The camera is exposed and the image output processes by the trigger signal.

The camera default setting is the input trigger signal is INVALID while at the low status of this signal. When the exposure starts while the image output by the next trigger signal, please change the camera setting (Device code: 00H, Command No. :13H) to accept the trigger signal while the image outputs.

The noise appears on the image when the exposure begins while the image is output. The noise appears on the image when the start exposure while the image is output. In this case, please change the “H reset” for the exposure start mode (Device code: 00H, Command No. : 12H) to change the exposure start point to the next HD timing.

2) UserOutput

The status of the UserOutput signal can change with the “UserOutputValue”.

a)High status (3.3V)

b)Low status (0V).

3)ExposureActive

The user can check the exposure time with the ExposureActive signal.

a)High status (3.3V): The camera is exposing

b)Low status (0V): The camera is not exposed

4)TriggerAuxiliary

The TriggerAuxiliary signal is the input trigger signal.

5) TriggerInternal

The TriggerInternal signal is the input trigger signal with the trigger delay time.

6) SensorReadOut

The SensorReadOut signal is the FVAL signal, which is the image output period of the time.

7) StrobeSignal

The StrobeSignal signal is the strobe control signal.

FV-G200B1

5/38

User’s Guide Rev. 1.02

 

Image 5
Contents FV-G200B1 User’s Guide Rev GigE Vision VGA Monochrome CCD Camera FV-G200B1Table of Contents RJ45 Connector Connector SpecificationsPower-I/O Connector DC Iris Lens ConnectorFV-G200B1 User’s Guide Rev Or equivalent connector Equivalent Circuit for the Input Pin of the I/O ConnectorVertical Timing Full Scanning Horizontal Timing3 1/4 Partial Scanning 2 1/2 Partial ScanningFval Lval SUB AOI Area of InterestPixel Transferring Image Timing Normal ModePulse Width Trigger Mode Input Trigger signal Exposure Timing with the Positive Polarity Trigger SignalTrigger signal Trigger signal With Photocoupler delayEdge Preset Trigger Mode 14/38 15/38 16/38 Reset mode Communication Format Communication SettingsCommunication Method Name Descriptions 【Example Code】Reading the data from the command 00H Camera Command List Device Code Camera Control Command22/38 23/38 24/38 Underline settings are the factory default settings Descriptions of the Camera Control Commands Device code26/38 27/38 28/38 29/38 30/38 AGC Descriptions of the Camera Commands Device code32/38 33/38 34/38 GenICam command Device Command Function GenICam Command / Camera Command Reference Table2EH 37/38 38/38