Ricoh FV-G200B1 manual 【Example Code】Reading the data from the command 00H

Page 20

【Example Code】Reading the data from the command 00H

Command to send: 02H, 00H, 00H, 01H, 00H, 03H

SOF	Device Code	Read/Write	Page Selection	Command Code	Data Length	Data	EOF
(8bit)	(6bit)	(1bit)	(1bit)	(8bit)	(8bit)	(1byte)	(8bit)

02H		00H		00H	01H	00H	03H

Command to receive upon a successful communication: 02H, 01H, 00H, 03H (assuming the data is 00H)

SOF	Data Length	Data	EOF
(8bit)	(8bit)	(n bytes)	(8bit)

02H	01H	00H	03H

【Sequence for the saving commands to the EEPROM】

Please use the following sequence for saving the commands to the EEPROM.

1)Set “1” to the 80H.0 to enable writing to the EEPROM.

2)Send the save data with the page selection “1”.

3)The camera sends back one of the following receiving codes after writing the EEPROM. 01H: OK

17H: EEPROM write error

4)80.0H is cleared to “0” automatically after writing the EEPROM.

Note1: The data cannot be saved to the EEPROM when 80H.0 is “0”.

Note2: When saving the consecutive sequence of commands, the above steps, 1) to 4), are necessary only once.

i.e.) saving the commands “10H, 11H, 12H, 13H”, or “22H, 23H, 24H”, etc.

Note3: When saving the non-consecutive sequence of commands, the above steps, 1) to 4), are necessary for the same number of times.

i.e.) saving the commands “10H, 13H, 19H, 1BH” or “20H, 23H, 25H”, etc.

	FV-G200B1	20/38
	User’s Guide Rev. 1.02	20/38
	User’s Guide Rev. 1.02

Image 20

Contents GigE Vision VGA Monochrome CCD Camera FV-G200B1 FV-G200B1 User’s Guide RevTable of Contents Connector Specifications RJ45 ConnectorDC Iris Lens Connector Power-I/O ConnectorFV-G200B1 User’s Guide Rev Equivalent Circuit for the Input Pin of the I/O Connector Or equivalent connectorHorizontal Timing Vertical Timing Full Scanning2 1/2 Partial Scanning 3 1/4 Partial ScanningAOI Area of Interest Fval Lval SUBPixel Transferring Image Timing Normal ModePulse Width Trigger Mode Exposure Timing with the Positive Polarity Trigger Signal Input Trigger signalTrigger signal Trigger signal With Photocoupler delayEdge Preset Trigger Mode 14/38 15/38 16/38 Reset mode Communication Format Communication SettingsCommunication Method Name Descriptions 【Example Code】Reading the data from the command 00H Camera Control Command Camera Command List Device Code22/38 23/38 24/38 Descriptions of the Camera Control Commands Device code Underline settings are the factory default settings26/38 27/38 28/38 29/38 30/38 Descriptions of the Camera Commands Device code AGC32/38 33/38 34/38 GenICam Command / Camera Command Reference Table GenICam command Device Command Function2EH 37/38 38/38