30/38 | Ricoh FV-G200B1 manual

Command No.

Command Description

[Active time (us) for the strobe signal]

90H:

Initial data: STROBEON _I[23..0] =10, STROBEDELAY _F[7..0] = 0, data range: 0 to 2,000,000

STROBEON_I[7..0]

91H:

Active time for the strobe signal = (STROBEON _I[23..0]). (STROBEON _F[7..0]) useconds

STROBEON_I[15..8]

92H:

Active time for the strobe signal is set as below.

STROBEON_I[23..16]

0: No strobe signal output

93H:

1 to 9: 10 us

STROBEON_F[7..0]

Greater than 9: set value

[Output signal selection for the power-I/O connector] Initial data: OUTSEL[7..0] = 20H

F0H:

Sets the output signal from the power/IO connector.

OUTSEL

D[7..0]

[7..0]

D7 to D4:

Output signal for 3pin of the power/IO connector

0: FrameTriggerWait signal

1: UserOutput signal

2: ExposureActive signal

3: TriggerAuxiliary signal

4: TriggerInternal signal (after mask and delay process)

5: SensorReadOut signal

6 to F: No Function (Prohibited setting. Do not set these values)

D3 to D0:

Output signal for 2pin of the power/IO connector

0: FrameTriggerWait signal

1: UserOutput signal

2: ExposureActive signal

3: TriggerAuxiliary signal

4: TriggerInternal signal (after mask and delay process)

5: SensorReadOut signal

6 to F: No Function (Prohibited setting. Do not set these values)

Note: When “UserOutput signal” is selected, set the status of the signal with “UserOutput signal for the

power/IO

connector (TEST2-D3,4)”.

[UserOutput signal for the power-I/O connector] Initial data: TEST2[7..0] = 00H

F1H: TEST2[7..0]

Sets the status of the UserOutput signal.

D[7..0]

D7 to D5:

No function

Always set as “000”

D4:

UserOutput signal for 3pin of the power/IO connector

0: Low

1: High

D3:

UswerOuput signal for 2pin of the power/IO connector

0: Low

1: High

D2 to D0:

No function

Always set as “000”

Note: The UserOutput signal is enabled whenever “UserOutput signal” is selected at the “Output signal

selection (OUTSEL)”.

	FV-G200B1	30/38
	User’s Guide Rev. 1.02	30/38
	User’s Guide Rev. 1.02