Remote Control
Install Remote Battery Cell
1. | Pin Hole | 2. | Battery Cell Holder | 3. |
| ||||
Back |
|
|
|
|
of |
|
| Lithium Cell Battery |
|
Remote |
|
| With Positive (+) |
|
|
|
| Terminal Up |
|
Replace
+Battery Cell
Holder
1.Turn remote over and insert a pin or straightened paper clip in the pin hole to remove the battery holder.
2.Insert battery cell in battery holder so positive (+) terminal faces up.
3.Replace battery holder.
Notes: Never place anything heavy on top of the remote or lay it upside down.
Replace battery when camcorder fails to respond to remote.
Remove the battery from the remote if it will not be used for a month or more. This will prevent possible damage from battery leakage. If leakage occurs, wipe up the liquid inside the compartment and replace
the battery.
Cautions: Lithium cell battery. Replace only with Duracell No. DL2025. Use of other cells may present a risk of fire or explosion. Must be disposed of properly. Never handle a punctured or leaking cell. May cause burns or personal injury.
Keep out of the hands of children. Can cause death or injury if swallowed. If swallowed, consult a physician immediately for emergency treatment.
The lithium cell used in this device may explode resulting in a fire or chemical burn if mistreated. Do not recharge, disassemble, heat above 212˚F (100˚C), or incinerate.
Never use metallic tweezers to hold the cell, and never short circuit the + and – sides of the cell.
Remote Sensor
| VCR |
| REC |
ON/OFF | TITLE |
|
|
| REW |
STOP |
| SCAN | F. |
DISPLAY |
|
| FWD |
T | ZOOM | W |
PLAY
| PAUSE |
STANDBY | RECORDCAMERA |
Remote Sensor
| FADE | B.LIGHT |
|
|
| EDIT+ |
|
EDIT– | D•S•E |
| |
A/M | FOCUS | SELECT | |
VCR REC |
|
| SCENE |
| AUTO |
|
|
The remote operates the camcorder by infrared light, so it is protected from electrical and sound interference.
However, the remote must be aimed directly at the camcorder’s remote sensor. There cannot be any obstructions between them.
Note: The camcorder may not respond to the remote control if the camcorder’s remote sensor is exposed to direct sunlight or strong artificial light.
15