Sanyo DSR-C100 instruction manual Monitor display Camera status

Page 11

Warning indicator

				Caution indicator
		Indicator
Monitor display	Warning	Caution	Caution	Camera status
	Warning	(ON)	(OFF)
		(ON)	(OFF)
				4 When there is 20 minutes or less of
				recording time remaining in the
				post-alarm recording area, or
4	6			When post-alarm 2 recording is
4	6			complete (suspicion recording
				complete (suspicion recording
<ALARM REC FULL> HDD WARN				possible)

					5 When there is a problem with the
	SYSTEM				camera hardware (recording is not
	SYSTEM				possible)
	ERROR	Fast	Fast	Off	possible)
		Fast	Fast		6 When there is a problem with the
		flashes	flashes		6 When there is a problem with the
		flashes	flashes		hard disk (recording is not possible)
					hard disk (recording is not possible)
LOW BATT					7 When Ni-Cd battery is not installed
7	5				or not connected (NO BATT)
7	5				When there is a problem with the
					When there is a problem with the
NO BATT					Ni-Cd battery (LOW BATT)

When time setting has not been carried out

During hard disk initialization (ö) During memory card initialization

Note: If you do not need the caution indicator to operate (lighting or flashing), you can set it to remain off at all times by setting CAUTION LED to “OFF” in the SYSTEM SET screen.

However, the ö mark indicates times when the caution indicator flashes regardless of the CAUTION LED setting.

10

English

Image 11

Contents DSR-C100 Contents Formatting the memory card Function OperationsDeclaration of Conformity Information to UserPrecautions Accessories FeaturesPart Names and Functions Front Panel Control terminals OFF Indicator Monitor display Camera statusMonitor display Camera status Ni-Cd Backup Battery Installing and HandlingInstalling the Ni-Cd battery Basic connections Hold-up switch B Suspicion switchConnecting the power supply ConnectionsComputer Connection to a computerRS-232C cable connection Hard disk recording areas Hard DiskChecking the hard disk Protecting the hard diskFrom Recording to Playback Turn on the power. See page 1Press the Menu button Hard Disk Standby ModeSetting to standby mode Canceling standby modeMemo Menu Settings Menu screen display BClock settings BSystem settingsBefore setting Setting the Clock Clock SETSetting example To set the clock to 151520 on 2 August System Settings System SET Palette Hard disk initializationChanging the alarm capacity Hard Disk Capacity Settings HDD SETUse the Cursor l button to select Minute Use the Cursor dor c button to set Mode ... onUse the Cursor l button to select Week SUN Summer Time Settings Summer TIME/DAYLIGHT SET KEY Word SET File ID a Camera ID Comment KEY Word Setting KEY Word SETPress the SET button Entering a file ID 1 characterEnter ALL1 in same way Setting a camera ID 5 charactersEntering a comments up to 36 characters Button Example Set the password to CameraUse the Cursor jor l button to select Change PASSWORD-DELETE OLD Password Example To change the initial setting of END to CMR Setting a password for initializing the hard diskOLD Password Correcting characters For Camera ID and Comment settingsFor Password or Camera ID setting 4Checking the Summer TIME/DAYLIGHT SET settings 1Checking the Clock SET settings2Checking the HDD SET settings 3Checking the System SET settingsImage quality Setting the Recording MethodIllumination Post-alarm POST-1 recording Pre-alarm PRE1 recordingSuspicion recording Pre-alarm recording flow 2Number of suspicion recording images Pre-alarm recordingScreen displays 1Display during recordingRelease the H HOLD-UP switch to stop recording Post-alarm recordingPress and hold the H HOLD-UP switch rear panel Pre-alarm 2 PRE2 recording starts automatically Backup recording