Sanyo DSR-C100 instruction manual Screen displays, Pre-alarm recording, 1Display during recording

Page 43

Screen displays	1	PRE1-ALARM REC
1Display during recording
• During recording, the screen display will switch off
after 30 seconds have passed. You can make the
screen display re-appear by pressing the SET or
CURSOR button.		REMAIN SHOTS: 6834 2
• The screen display can be set to switch off immediately		REMAIN SHOTS: 6834 2
• The screen display can be set to switch off immediately
from the start of recording. To do this, set “CAUTION
LED” on the SYSTEM SET screen to OFF. To re-display
the screen, set it back to ON. (See page 23)
2Number of suspicion recording images

Pre-alarm recording

1Press the MENU button.

The MAIN MENU screen will be displayed.

If the MAIN MENU screen remains displayed for about 30 seconds, pre-alarm recording will then start automatically.

MENU	NTSC
MENU	SET
	PAL
1	2

(MAIN MENU)

2Use the CURSOR (jor l) button to select “RECORD START” and then press the SET button.

“PRE1-ALARM REC” will be displayed and pre-alarm (PRE1) recording will start.

The warning indicator and caution indicator both light during pre-alarm recording.

MENU

SET

RECORD START

PLAYBACK

SETTINGS

CONDITION

PRE1-ALARM REC

REMAIN SHOTS: 6834

Note: Pre-alarm recording will continue with the images being recorded in the pre-alarm (PRE1) area of the hard disk until the hold-up switch or suspicion switch at the back of the camera is pressed.

3Press the MENU button to stop recording. The display will return to the MAIN MENU screen.

42

English

Image 43

Contents DSR-C100 Contents Formatting the memory card Function OperationsDeclaration of Conformity Information to UserPrecautions Accessories FeaturesPart Names and Functions Front Panel Control terminals OFF Indicator Monitor display Camera statusMonitor display Camera status Ni-Cd Backup Battery Installing and HandlingInstalling the Ni-Cd battery Basic connections Hold-up switch B Suspicion switchConnecting the power supply ConnectionsRS-232C cable connection Connection to a computerComputer Hard disk recording areas Hard DiskChecking the hard disk Protecting the hard diskFrom Recording to Playback Turn on the power. See page 1Press the Menu button Hard Disk Standby ModeSetting to standby mode Canceling standby modeMemo Menu Settings Menu screen display BClock settings BSystem settingsSetting example To set the clock to 151520 on 2 August Setting the Clock Clock SETBefore setting System Settings System SET Palette Hard disk initializationChanging the alarm capacity Hard Disk Capacity Settings HDD SETUse the Cursor l button to select Week SUN Use the Cursor dor c button to set Mode ... onUse the Cursor l button to select Minute Summer Time Settings Summer TIME/DAYLIGHT SET KEY Word SET File ID a Camera ID Comment KEY Word Setting KEY Word SETPress the SET button Entering a file ID 1 characterEnter ALL1 in same way Setting a camera ID 5 charactersEntering a comments up to 36 characters Use the Cursor jor l button to select Example Set the password to CameraButton Change PASSWORD-DELETE OLD Password Example To change the initial setting of END to CMR Setting a password for initializing the hard diskOLD Password For Password or Camera ID setting For Camera ID and Comment settingsCorrecting characters 4Checking the Summer TIME/DAYLIGHT SET settings 1Checking the Clock SET settings2Checking the HDD SET settings 3Checking the System SET settingsIllumination Setting the Recording MethodImage quality Post-alarm POST-1 recording Pre-alarm PRE1 recordingSuspicion recording Pre-alarm recording flow 2Number of suspicion recording images Pre-alarm recordingScreen displays 1Display during recordingPress and hold the H HOLD-UP switch rear panel Post-alarm recordingRelease the H HOLD-UP switch to stop recording Pre-alarm 2 PRE2 recording starts automatically Backup recording