Sanyo DSR-C100 Hard Disk Standby Mode, Setting to standby mode, Canceling standby mode

Page 19

HARD DISK STANDBY MODE

When shooting or recording ends, switch the hard disk to standby mode.

Setting to standby mode

1Press the MENU button.

The MAIN MENU screen will be displayed.

 

(MAIN MENU)

MENU

RECORD START

 

PLAYBACK

 

SETTINGS

 

CONDITION

2While pressing the MENU button, press the SET button.

After the current image has been recorded on the hard disk, the disk will change to standby mode. During recording, the message “DISK CLOSING” will be displayed for approximately 2 seconds.

Furthermore, the warning indicator and caution indicator will both switch off while the hard disk is in standby mode.

MENU SET

DISK CLOSING

Note:

The caution indicator will flash until the hard disk changes to standby mode. None of the setting details will change when the hard disk is in standby mode.

This operation (DISK CLOSING) cannot be carried out using the camera control unit (sold separately).

Canceling standby mode

If you press the MENU button, the MAIN MENU screen will be displayed.

To start pre-alarm recording, select RECORD START and then press the SET button. Furthermore, if the MAIN MENU screen remains displayed for 30 seconds, the camera will change automatically to pre-alarm recording.

Press the MENU button.

Pre-alarm recording will then start.

PRE1-ALARM REC

MENU

REMAIN SHOTS: 6834

Note: The warning indicator and caution indicator will both flash while the hard disk contents are being checked. When pre-alarm recording starts, the caution indicator will light.

18

English

Image 19
Contents DSR-C100 Contents Formatting the memory card Function OperationsDeclaration of Conformity Information to UserPrecautions Accessories FeaturesPart Names and Functions Front Panel Control terminals OFF Indicator Monitor display Camera statusMonitor display Camera status Ni-Cd Backup Battery Installing and HandlingInstalling the Ni-Cd battery Basic connections Hold-up switch B Suspicion switchConnecting the power supply ConnectionsRS-232C cable connection Connection to a computerComputer Hard disk recording areas Hard DiskChecking the hard disk Protecting the hard diskFrom Recording to Playback Turn on the power. See page 1Press the Menu button Hard Disk Standby ModeSetting to standby mode Canceling standby modeMemo Menu Settings Menu screen display BClock settings BSystem settingsSetting example To set the clock to 151520 on 2 August Setting the Clock Clock SETBefore setting System Settings System SET Palette Hard disk initializationChanging the alarm capacity Hard Disk Capacity Settings HDD SETUse the Cursor l button to select Week SUN Use the Cursor dor c button to set Mode ... onUse the Cursor l button to select Minute Summer Time Settings Summer TIME/DAYLIGHT SET KEY Word SET File ID a Camera ID Comment KEY Word Setting KEY Word SETPress the SET button Entering a file ID 1 characterEnter ALL1 in same way Setting a camera ID 5 charactersEntering a comments up to 36 characters Use the Cursor jor l button to select Example Set the password to CameraButton Change PASSWORD-DELETE OLD Password Example To change the initial setting of END to CMR Setting a password for initializing the hard diskOLD Password For Password or Camera ID setting For Camera ID and Comment settingsCorrecting characters 4Checking the Summer TIME/DAYLIGHT SET settings 1Checking the Clock SET settings2Checking the HDD SET settings 3Checking the System SET settingsIllumination Setting the Recording MethodImage quality Post-alarm POST-1 recording Pre-alarm PRE1 recordingSuspicion recording Pre-alarm recording flow 2Number of suspicion recording images Pre-alarm recordingScreen displays 1Display during recordingPress and hold the H HOLD-UP switch rear panel Post-alarm recordingRelease the H HOLD-UP switch to stop recording Pre-alarm 2 PRE2 recording starts automatically Backup recording