Sanyo DSR-C100 instruction manual Installing the Ni-Cd battery

Page 13

Installing the Ni-Cd battery

1Loosen the rear cover fixing screw (A) and open the cover. (The screw cannot be removed from the cover.)

2Insert the battery into the battery compartment so that the Ni-Cd battery label is facing upward.

3Connect the battery plug to the connector.

4Close the rear cover and tighten the rear cover fixing screw (A).

A

1

WARNING

•Do not short the battery terminals and do not attempt to disassemble or modify the battery.

•Do not drop the battery or subject it to strong shocks.

•Do not place the battery into fire, as it may explode.

•Do not expose the battery to moisture.

•Do not place the battery into water or let the terminals of the battery get wet.

3

2

DANGER

The following precautions must be observed at all times, otherwise the battery may leak, overheat or explode.

•Never peel off or scratch the outer tube.

•Do not use in any other appliance except for this camera.

•Do not carry the battery by holding the connectors or lead wires.

If the fluid inside the battery gets into eyes, it may cause blindness. Do not rub the eyes, wash the affected area immediately with clean water, and then seek medical advice.

If the fluid inside the battery gets onto the skin or clothing, it may injure the skin, so wash the affected area immediately with clean water.

12

English

Image 13

Contents DSR-C100 Contents Formatting the memory card Function OperationsDeclaration of Conformity Information to UserPrecautions Accessories FeaturesPart Names and Functions Front Panel Control terminals OFF Indicator Monitor display Camera statusMonitor display Camera status Ni-Cd Backup Battery Installing and HandlingInstalling the Ni-Cd battery Connecting the power supply Hold-up switch B Suspicion switchConnections Basic connectionsRS-232C cable connection Connection to a computerComputer Hard disk recording areas Hard DiskChecking the hard disk Protecting the hard diskFrom Recording to Playback Turn on the power. See page 1Setting to standby mode Hard Disk Standby ModeCanceling standby mode Press the Menu buttonMemo Menu Settings Menu screen display BClock settings BSystem settingsSetting example To set the clock to 151520 on 2 August Setting the Clock Clock SETBefore setting System Settings System SET Palette Hard disk initializationChanging the alarm capacity Hard Disk Capacity Settings HDD SETUse the Cursor l button to select Week SUN Use the Cursor dor c button to set Mode ... onUse the Cursor l button to select Minute Summer Time Settings Summer TIME/DAYLIGHT SET KEY Word SET File ID a Camera ID Comment KEY Word Setting KEY Word SETPress the SET button Entering a file ID 1 characterEnter ALL1 in same way Setting a camera ID 5 charactersEntering a comments up to 36 characters Use the Cursor jor l button to select Example Set the password to CameraButton Change PASSWORD-DELETE OLD Password Example To change the initial setting of END to CMR Setting a password for initializing the hard diskOLD Password For Password or Camera ID setting For Camera ID and Comment settingsCorrecting characters 2Checking the HDD SET settings 1Checking the Clock SET settings3Checking the System SET settings 4Checking the Summer TIME/DAYLIGHT SET settingsIllumination Setting the Recording MethodImage quality Post-alarm POST-1 recording Pre-alarm PRE1 recordingSuspicion recording Pre-alarm recording flow Screen displays Pre-alarm recording1Display during recording 2Number of suspicion recording imagesPress and hold the H HOLD-UP switch rear panel Post-alarm recordingRelease the H HOLD-UP switch to stop recording Pre-alarm 2 PRE2 recording starts automatically Backup recording