Sanyo DSR-C100 instruction manual Control terminals

Page 9

Control terminals

H

S

WARNING

DC13.8V

GND

GND

GND

1 23 4 5 67

5VIDEO OUT terminal (BNC plug)

This terminal is used to connect the camera to a component such as a monitor or camera control unit.

6RESET button

Press the RESET button if an abnormality occurs with the camera. Settings are not changed when the camera is reset in this way.

7Warning indicator

•The warning indicator lights when the camera power is turned on.

•It flashes when there is a hard disk error or if there is a problem with the backup battery.

	Terminal	Signal		Input/output voltage
1	H (HOLD-UP)	Alarm switch input signal	2.5	V or higher when alarm switch off/
			0.4	V or lower when alarm switch on
2	GND	Alarm switch and suspicion switch ground	0 V

3	S (SUSPICION)	Suspicion switch input signal	2.5	V or higher when suspicion switch off/
			0.4	V or lower when suspicion switch on
4	GND	Warning ground	0 V

5	WARNING	Warning signal output	3.3	V or higher when warning generated

6	GND	Power supply ground	0 V

7	DC 13.8 V	Power supply input	13.8 V DC

8

English

Image 9

Contents DSR-C100 Contents Formatting the memory card Function OperationsDeclaration of Conformity Information to UserPrecautions Accessories FeaturesPart Names and Functions Front Panel Control terminals OFF Indicator Monitor display Camera statusMonitor display Camera status Ni-Cd Backup Battery Installing and HandlingInstalling the Ni-Cd battery Connecting the power supply Hold-up switch B Suspicion switchConnections Basic connectionsConnection to a computer RS-232C cable connectionComputer Hard disk recording areas Hard DiskChecking the hard disk Protecting the hard diskFrom Recording to Playback Turn on the power. See page 1Setting to standby mode Hard Disk Standby ModeCanceling standby mode Press the Menu buttonMemo Menu Settings Menu screen display BClock settings BSystem settingsSetting the Clock Clock SET Setting example To set the clock to 151520 on 2 AugustBefore setting System Settings System SET Palette Hard disk initializationChanging the alarm capacity Hard Disk Capacity Settings HDD SETUse the Cursor dor c button to set Mode ... on Use the Cursor l button to select Week SUNUse the Cursor l button to select Minute Summer Time Settings Summer TIME/DAYLIGHT SET KEY Word SET File ID a Camera ID Comment KEY Word Setting KEY Word SETPress the SET button Entering a file ID 1 characterEnter ALL1 in same way Setting a camera ID 5 charactersEntering a comments up to 36 characters Example Set the password to Camera Use the Cursor jor l button to selectButton Change PASSWORD-DELETE OLD Password Example To change the initial setting of END to CMR Setting a password for initializing the hard diskOLD Password For Camera ID and Comment settings For Password or Camera ID settingCorrecting characters 2Checking the HDD SET settings 1Checking the Clock SET settings3Checking the System SET settings 4Checking the Summer TIME/DAYLIGHT SET settingsSetting the Recording Method IlluminationImage quality Post-alarm POST-1 recording Pre-alarm PRE1 recordingSuspicion recording Pre-alarm recording flow Screen displays Pre-alarm recording1Display during recording 2Number of suspicion recording imagesPost-alarm recording Press and hold the H HOLD-UP switch rear panelRelease the H HOLD-UP switch to stop recording Pre-alarm 2 PRE2 recording starts automatically Backup recording