Sanyo DSR-C100 instruction manual Connection to a computer, RS-232C cable connection, Computer

Page 15

Connection to a computer

If the camera is connected to a computer, you can then use the accessory application software to perform operations such as data transfer and printing of images by the computer.

The method of connecting the power supply and peripheral devices is the same as described in “Basic connections”.

	(A) Hold-up switch (B) Suspicion switch	(C) Warning signal check output
	(A) Hold-up switch (B) Suspicion switch	(connect a lamp or similar device)
		(connect a lamp or similar device)

1

2

3

13.8 V DC

•RS-232C cable connection

•USB cable connection

Computer

Computer

Note:

•

•

•

When connecting an RS-232C cable, it may be necessary to use a separate conversion adaptor depending on the type of computer being used.

When connecting a USB cable, take note of the differences in the shapes of the connectors at the computer end and at the camera end.

Only connect a cable to the USB connector when using the application software. If the USB cable is connected to the camera at other times, normal operations such as recording cannot be carried out.

14

English

Image 15

Contents DSR-C100 Contents Formatting the memory card Function OperationsDeclaration of Conformity Information to UserPrecautions Accessories FeaturesPart Names and Functions Front Panel Control terminals OFF Indicator Monitor display Camera statusMonitor display Camera status Ni-Cd Backup Battery Installing and HandlingInstalling the Ni-Cd battery Basic connections Hold-up switch B Suspicion switchConnecting the power supply ConnectionsConnection to a computer RS-232C cable connectionComputer Hard disk recording areas Hard DiskChecking the hard disk Protecting the hard diskFrom Recording to Playback Turn on the power. See page 1Press the Menu button Hard Disk Standby ModeSetting to standby mode Canceling standby modeMemo Menu Settings Menu screen display BClock settings BSystem settingsSetting the Clock Clock SET Setting example To set the clock to 151520 on 2 AugustBefore setting System Settings System SET Palette Hard disk initializationChanging the alarm capacity Hard Disk Capacity Settings HDD SETUse the Cursor dor c button to set Mode ... on Use the Cursor l button to select Week SUNUse the Cursor l button to select Minute Summer Time Settings Summer TIME/DAYLIGHT SET KEY Word SET File ID a Camera ID Comment KEY Word Setting KEY Word SETPress the SET button Entering a file ID 1 characterEnter ALL1 in same way Setting a camera ID 5 charactersEntering a comments up to 36 characters Example Set the password to Camera Use the Cursor jor l button to selectButton Change PASSWORD-DELETE OLD Password Example To change the initial setting of END to CMR Setting a password for initializing the hard diskOLD Password For Camera ID and Comment settings For Password or Camera ID settingCorrecting characters 4Checking the Summer TIME/DAYLIGHT SET settings 1Checking the Clock SET settings2Checking the HDD SET settings 3Checking the System SET settingsSetting the Recording Method IlluminationImage quality Post-alarm POST-1 recording Pre-alarm PRE1 recordingSuspicion recording Pre-alarm recording flow 2Number of suspicion recording images Pre-alarm recordingScreen displays 1Display during recordingPost-alarm recording Press and hold the H HOLD-UP switch rear panelRelease the H HOLD-UP switch to stop recording Pre-alarm 2 PRE2 recording starts automatically Backup recording