MAIN MENU | SVAT ELECTRONICS |
| nowyoucansee |
System Maintenance
System maintenance allows you to load system default settings, set up your
To enable auto-maintenance:
1.Select the drop down list, “AUTO MAINTAIN.”
2.Select
3.Select “APPLY” to save your changes.
To configure auto reboot:
1.Select the drop down list next to “AUTO REBOOT.”
2.Highlight how often you would like the system to reboot (daily, weekly or monthly) and press select.
3.Select the day and time you would like the automatic reboot to occur. NOTE: Time is based on the 24 hour clock.
4.Select “APPLY” to save your changes.
To update system:
A system update can be done if there is new software available for your DVR model. This should only be done if a SVAT representative recommends it.
1.Download the proper upgrade files from www.svat.com. Place these files onto a USB device.
2.Insert the USB flash drive into the appropriate jack on the left side of the
3.Select “SYSTEM UPDATE.” This will take a few minutes to complete. NOTE: Upon completion,
To load default
Loading default settings will restore all settings on your DVR to the default settings except your passwords and time adjustments.
1.Select “LOAD DEFAULT.”
2.You will be prompted, “Restoring defaults will erase all current settings, are you sure?” To restore default settings, select “OK,” if you do not wish to reset to default, select “CANCEL.”
3.Restoring defaults settings will take a few minutes.
To reboot the DVR:
1.Select “REBOOT.”
2.You will be prompted, “Are you sure to restart machine?” If yes, select “OK,” if not, “CANCEL.”
3.
40 | |
|
|