![](/images/new-backgrounds/1131275/131275117x1.webp)
CN2
CCD unit |
CN105
CN106
CN107
CN123
Front panel |
Washer(W3) |
Screw(B3 X8) |
Setscrew(3 X4) |
Screws(B3 X4)
4.Remove four screws (B3 × 10 : with washer). Disconnect the two connectors, CN2 and CN14 on the
Front unit Ass'y |
Screws |
(B3 X10: |
with washer) |
CN103 |
Screws |
(B3 X10: with washer) |
5.Remove setscrew (3 × 4) and remove the filter knob. Remove four screws (B3 × 8) and washers. Remove the
CCD unit from the Front unit Ass’y.
Note: When handling the CCD unit, pay attention not to stress each PA board.
Screws(B3 X8) |
|
Washers(W3) | Filter knob |
6.Remove the CCD unit from transport holder for replacement CCD unit supplied from the Sony Part Center.
When installing a new CCD unit, reverse the above procedures.
After the replacement is complete, perform several adjustments referring to Section
Note: When transporting the CCD unit that was removed from the unit, reuse the transport holder.
CCD unit
Transport holder
Screws(P3 X6)
|