Hasselblad 10026 service manual Focusing screen frame, Right hand wall, Mechanism plate

Page 11

3:3

Camera body 503CW

Disassembly

Focusing screen frame (22812)

Remove the two remaining screws (820015) holding the focusing screen frame to the right hand wall and lift the frame off.

Right hand wall (21095-1)

Remove (or cut) the foam plastic pad (22582) to get access to the three screws (820014). Remove the right hand wall.

Mechanism plate (21125-1)

Remove the damping ring (22287) by first removing screw (822605) and washer (810836). Put the screw (822605) back, to keep the spring (30384) in place.

Remove the screw (821631), washer (810532) and gear wheel (13112). Beneath the gear wheel remove washer (810826). Remove the mirror spring (814827).

Fig. 6.

Remove the mirror actuating lever (13362) from the rear of the right hand side wall together with the lens lock (13280).

22287	821631	814827
822605		13112

Fig. 6

Remove the following parts shown in Fig. 7.

1.Spring (814826)

2.Screw (821032)

3.Spring (816914)

4.S-arm (21167) and hub (840701)

5.Release arm (13357) including push rod (22369)

6.Stop lever (22769), clip (817119) and spring (816752)

Remove the remaining six screws, the stop angle (13432) and adjustable pawl (13170).

Separate the mechanism plate from the right hand wall.

		3
		6
1
4	2	5

Fig. 7

Revision 0

October 1996

Image 11

Contents Göteborg Sweden Victor Hasselblad ABContents list Camera body 503CW Flash metering circuit redesigned 503CX Updated pages 503CXiSignal arm shortened 501C and 503CXi Fitted with wrong spacers 503C/M and 503CX04/01 New CD-ROM Version Camera type General descriptionRelease sequence Tools Used for Tool No DescriptionTool No Description Used for Camera shell Rear plate 30300 including auxiliary shutter Circuit board 22575 *22882Front bayonet plate Mechanism plate Focusing screen frameRight hand wall Gear housing Reassembly 816802 Fitting the mechanism plate to the right hand wall 821631 13108 814827 13355 13280 13362 Rear plate Intermediate gear Perform the necessary adjustment as described in sectionFront plate Adjustment Focal length Adjustment of the front key’s angular positionAngle 15-16 o with the bayonet plate tool 904644 pushed Adjustment of the release mechanism 15 mm Adjustment of the release sequence Fitting the damping ring Fitting the Circuit board 22575 *22882 Adjustment Fitting the camera body into the shellFinal checks 510 Camera body 503CW 511 Camera body 503CW 512 Camera body 503CW 513 Camera body 503CW Front gear Front plate reassemblyFront bayonet plate Exchanging the auxiliary shutter Exchanging the mirrorShim washers Revision May Pos Pcs Spare Description Remark May Camera body 503CW Camera body 503CW Camera body 503CW September Camera body 503CW Camera body 503CW Camera body 503CW Camera body 503CW Camera body 503CW October May Camera body 503CW Camera body 503CW 151 Spare parts not listed are the same as for 503CW 152 152 153 153 154 154 155 Coupling Crank support 161 Pos Pcs No Spare Part No Description Remark 162 Pos Pcs Spare Description Remark 163 163 171 171 172 172 173 173 174 174 175 175 181 181 182 182 183 183 184 184 185 January 191 October 192 192 193 193