Hasselblad 10026 service manual Fitting the mechanism plate to the right hand wall

Page 15

4:3

Camera body 503CW

Reassembly

Fitting the mechanism plate to the right hand wall

On the mechanism plate fit the upper and lower connecting rods to the pins on the gear wheels. (13100) for the upper shutter and (13101) for the lower shutter. Lubricate with grease. Position the auxiliary shutter stop (22436) in place.

Place the mechanism plate in position on the right hand wall. Attach the adjustable pawl assembly (13170) with two screws (820022). Lubricate the pawl with a drop of oil and ensure that it is free to operate. Attach the stop angle (13432) with screw (821017).

Secure the mechanism plate with the remaining three screws (823015), (820020) and (820015).

Note! The longer connecting rod (13101) which operates the lower shutter is fitted below the lower-left mounting post behind the signal arm.

Fig. 17.

13100	823015	22436	820020	820022
				13170
13101	820015		13432

Fig. 17

Connect the push rod (22369) to the release arm (13357). Place the arm on the pre-greased pin (836514).

Fit the S-arm (21167), hub (840701), spring (816914) and secure into position using screw (821032). Check for ease of operation.

Connect the spring 816914 to the S-arm and position the straight end to the pin on the shutter release connecting rod reverse side. Connect spring (814826) between the two pins. Check for ease of operation. Fig. 18.

	814826
816914	21167	13357

Fig. 18

Revision 1

May 2000

Image 15

Contents Göteborg Sweden Victor Hasselblad ABContents list Camera body 503CW Flash metering circuit redesigned 503CX Updated pages 503CXiSignal arm shortened 501C and 503CXi Fitted with wrong spacers 503C/M and 503CX04/01 New CD-ROM Version Camera type General descriptionRelease sequence Tools Used for Tool No DescriptionTool No Description Used for Camera shell Circuit board 22575 *22882 Front bayonet plateRear plate 30300 including auxiliary shutter Focusing screen frame Right hand wallMechanism plate Gear housing Reassembly 816802 Fitting the mechanism plate to the right hand wall 821631 13108 814827 13355 13280 13362 Rear plate Perform the necessary adjustment as described in section Front plateIntermediate gear Adjustment Focal length Adjustment of the front key’s angular positionAngle 15-16 o with the bayonet plate tool 904644 pushed Adjustment of the release mechanism 15 mm Adjustment of the release sequence Fitting the damping ring Fitting the Circuit board 22575 *22882 Adjustment Fitting the camera body into the shellFinal checks 510 Camera body 503CW 511 Camera body 503CW 512 Camera body 503CW 513 Camera body 503CW Front gear Front plate reassemblyFront bayonet plate Exchanging the auxiliary shutter Exchanging the mirrorShim washers Revision May Pos Pcs Spare Description Remark May Camera body 503CW Camera body 503CW Camera body 503CW September Camera body 503CW Camera body 503CW Camera body 503CW Camera body 503CW Camera body 503CW October May Camera body 503CW Camera body 503CW 151 Spare parts not listed are the same as for 503CW 152 152 153 153 154 154 155 Coupling Crank support 161 Pos Pcs No Spare Part No Description Remark 162 Pos Pcs Spare Description Remark 163 163 171 171 172 172 173 173 174 174 175 175 181 181 182 182 183 183 184 184 185 January 191 October 192 192 193 193