Hasselblad 10026 service manual Exchanging the mirror, Exchanging the auxiliary shutter

Page 34

6:3

Camera body 503CW

Auxillary shutter & Mirror

Exchanging the mirror (22775)

Release the camera.

Inside the mirror box, remove the clip "A" and disengage the arm (22781) from the mirror frame. Remove the washer (810649) located behind the arm and the frame.

Remove the sleeve (22800). Fig. 58.

Carefully wind on until the mirror is visible in the front plate cut-away.

Remove the mirror (22775) and the light trap (22776) which is placed underneath the mirror.

Fig. 59.

810649

22781

22800

"A"

Fig. 58

After a new mirror has been mounted in to the frame check for ease of operation.

Mount a new sleeve (22800) with the counter sunk side facing out.

Note! If the spring (22804) has to be replaced, the new one should be glued in the mirror frame with

Loctite 480.

Fig. 59

Exchanging the auxiliary shutter

Note! For convenience use the aux. shutter jig V-5423 when removing/mounting the pins (811108).

Remove the two pins (811108), spring retainer, spring (816805) and lever 13185.

Remove the safety lacquer and loosen the locking screws (825661). Remove the hubs (840514).

The upper shutter flap and mirror frame can now be removed. Ensure that all adjustment washers on the shaft are retained. The lower shutter flap is dismantled in a similar manner. The light trap 13125 is held in place by two screws (821203).

Fig. 60.

825661

840514

816805

13185

13125

811108

Fig. 60

Revision 0

October 1996

Image 34

Contents Victor Hasselblad AB Göteborg SwedenContents list Camera body 503CW Fitted with wrong spacers 503C/M and 503CX Updated pages 503CXiSignal arm shortened 501C and 503CXi Flash metering circuit redesigned 503CX04/01 New CD-ROM Version General description Camera typeRelease sequence Tool No Description Tools Used forTool No Description Used for Camera shell Front bayonet plate Circuit board 22575 *22882Rear plate 30300 including auxiliary shutter Right hand wall Focusing screen frameMechanism plate Gear housing Reassembly 816802 Fitting the mechanism plate to the right hand wall 821631 13108 814827 13355 13280 13362 Rear plate Front plate Perform the necessary adjustment as described in sectionIntermediate gear Adjustment Adjustment of the front key’s angular position Focal lengthAngle 15-16 o with the bayonet plate tool 904644 pushed Adjustment of the release mechanism 15 mm Adjustment of the release sequence Fitting the damping ring Adjustment Fitting the camera body into the shell Fitting the Circuit board 22575 *22882Final checks 510 Camera body 503CW 511 Camera body 503CW 512 Camera body 503CW 513 Camera body 503CW Front plate reassembly Front gearFront bayonet plate Exchanging the mirror Exchanging the auxiliary shutterShim washers Revision May Pos Pcs Spare Description Remark May Camera body 503CW Camera body 503CW Camera body 503CW September Camera body 503CW Camera body 503CW Camera body 503CW Camera body 503CW Camera body 503CW October May Camera body 503CW Camera body 503CW 151 Spare parts not listed are the same as for 503CW 152 152 153 153 154 154 155 Coupling Crank support 161 Pos Pcs No Spare Part No Description Remark 162 Pos Pcs Spare Description Remark 163 163 171 171 172 172 173 173 174 174 175 175 181 181 182 182 183 183 184 184 185 January 191 October 192 192 193 193