Hasselblad 10026 service manual 15 mm

Page 23

5:5

Camera body 503CW

The push rod (22369) is adjusted so that it is set 0.15

mmbelow the release bar (30375) forward angle setting. Check by using the tool V-5942.

Adjust by gently bending (22369). Fig. 37.

Position tool V-5942 as shown and press against the front plate. The mechanism should not release.

When the tool is moved upwards the mechanism should release.

If a large adjustment is needed bend the release arm (13357) using tool V-2224. Bend forward for an earlier release and backwards for a delay in release. For a small adjustment the push rod (22369) can be bent.

Fig. 38.

Fig. 39 and 40.

Pre-release the camera shutter by operating the S-arm (21167) towards the angle stop (13432).

Shutter release should occur just as the S-arm strikes the angled stop and at the same time cam ”A” should

be positioned on stop ”B”.

Adjust by bending the S-arm with tool V-2202. Do not forget to re-adjust the angle stop (13432).

Minor adjustments can be carried out by just moving or bending the angle stop (13432) without any adjustments to the S-arm.

Note! That spring 816914 should not rest against the angle stop when the camera is completely released.

Adjustment

 

30375

22369

0.15 mm

Fig. 37

13357

Adjust here

with V-2224

Fig. 38

816914

13432

21167

Fig. 39

"A"

"B"

Fig. 40

Revision 0

October 1996

Image 23
Contents Göteborg Sweden Victor Hasselblad ABContents list Camera body 503CW Flash metering circuit redesigned 503CX Updated pages 503CXiSignal arm shortened 501C and 503CXi Fitted with wrong spacers 503C/M and 503CX04/01 New CD-ROM Version Camera type General descriptionRelease sequence Tools Used for Tool No DescriptionTool No Description Used for Camera shell Rear plate 30300 including auxiliary shutter Circuit board 22575 *22882Front bayonet plate Mechanism plate Focusing screen frameRight hand wall Gear housing Reassembly 816802 Fitting the mechanism plate to the right hand wall 821631 13108 814827 13355 13280 13362 Rear plate Intermediate gear Perform the necessary adjustment as described in sectionFront plate Adjustment Focal length Adjustment of the front key’s angular positionAngle 15-16 o with the bayonet plate tool 904644 pushed Adjustment of the release mechanism 15 mm Adjustment of the release sequence Fitting the damping ring Fitting the Circuit board 22575 *22882 Adjustment Fitting the camera body into the shellFinal checks 510 Camera body 503CW 511 Camera body 503CW 512 Camera body 503CW 513 Camera body 503CW Front gear Front plate reassemblyFront bayonet plate Exchanging the auxiliary shutter Exchanging the mirrorShim washers Revision May Pos Pcs Spare Description Remark May Camera body 503CW Camera body 503CW Camera body 503CW September Camera body 503CW Camera body 503CW Camera body 503CW Camera body 503CW Camera body 503CW October May Camera body 503CW Camera body 503CW 151 Spare parts not listed are the same as for 503CW 152 152 153 153 154 154 155 Coupling Crank support 161 Pos Pcs No Spare Part No Description Remark 162 Pos Pcs Spare Description Remark 163 163 171 171 172 172 173 173 174 174 175 175 181 181 182 182 183 183 184 184 185 January 191 October 192 192 193 193