Hasselblad 10026 service manual Camera shell, Disassembly

Page 9

3:1

Camera body 503CW

Camera shell

Remove the lens, film magazine, view finder, focusing screen and winding knob.

Remove the screw (830060), coupling (22767) and washer (22799).

Remove the leather (13374), shim (22473), screw (822701) and ISO selector knob (22495).

Do not damage the sliding contacts.

Remove the cap (22470) from the chassis connector and peel back the leather covering two screws

(823335). Remove these screws and firmly push the chassis connector into the body of the camera.

Remove the tripod foot (30763) held by six screws (829755). Remove the two rear screws (829755) and the two front screws (820781).

Fig. 1.

The chassis can now be separated from the camera shell. Ensure that the lens release button (13139), release button (22759), buffer (22367), teflon cone (103773) and distance washers (810620) are not dislodged from the camera shell and lost.

Fig. 2.

Operate the S-release on the camera by pressing the S-arm (21167) towards the stop. Remove the front gear cover (22876). Do not remove the side cover (22813) unless it is absolutely necessary.

The side cover is held in position by the spring (30775) secured with two screws (829425) and double sided tape.

Note! If removed, a new cover must be used when the camera is reassembled.

Disassembly

Fig. 1

Fig. 2

Revision 1

January 2001

Image 9

Contents Göteborg Sweden Victor Hasselblad ABContents list Camera body 503CW Signal arm shortened 501C and 503CXi Updated pages 503CXiFitted with wrong spacers 503C/M and 503CX Flash metering circuit redesigned 503CX04/01 New CD-ROM Version Camera type General descriptionRelease sequence Tools Used for Tool No DescriptionTool No Description Used for Camera shell Circuit board 22575 *22882 Front bayonet plateRear plate 30300 including auxiliary shutter Focusing screen frame Right hand wallMechanism plate Gear housing Reassembly 816802 Fitting the mechanism plate to the right hand wall 821631 13108 814827 13355 13280 13362 Rear plate Perform the necessary adjustment as described in section Front plateIntermediate gear Adjustment Focal length Adjustment of the front key’s angular positionAngle 15-16 o with the bayonet plate tool 904644 pushed Adjustment of the release mechanism 15 mm Adjustment of the release sequence Fitting the damping ring Fitting the Circuit board 22575 *22882 Adjustment Fitting the camera body into the shellFinal checks 510 Camera body 503CW 511 Camera body 503CW 512 Camera body 503CW 513 Camera body 503CW Front gear Front plate reassemblyFront bayonet plate Exchanging the auxiliary shutter Exchanging the mirrorShim washers Revision May Pos Pcs Spare Description Remark May Camera body 503CW Camera body 503CW Camera body 503CW September Camera body 503CW Camera body 503CW Camera body 503CW Camera body 503CW Camera body 503CW October May Camera body 503CW Camera body 503CW 151 Spare parts not listed are the same as for 503CW 152 152 153 153 154 154 155 Coupling Crank support 161 Pos Pcs No Spare Part No Description Remark 162 Pos Pcs Spare Description Remark 163 163 171 171 172 172 173 173 174 174 175 175 181 181 182 182 183 183 184 184 185 January 191 October 192 192 193 193